网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
A Cisco router has been configured with the following command:IP nat pool nat－test 192.168.6.10 192.168.6.20 netmask 255.255.255.0his is an example of what type of NAT?()
A. Static NAT
B. Dynamic NAT
C. Dynamic NAT with overload
D. Port Address Translation
E. None of the above
参考答案
更多 “ A Cisco router has been configured with the following command:IP nat pool nat－test 192.168.6.10 192.168.6.20 netmask 255.255.255.0his is an example of what type of NAT?() A. Static NATB. Dynamic NATC. Dynamic NAT with overloadD. Port Address TranslationE. None of the above ” 相关考题
考题
请参照图5-1，在路由器上完成销售部网段NAT的部分配置。……Router(config)ip nat pool xiaoshou 61.246.100.99 61.246.100.99 netmask(7)!设置地址池!Router(config)access-list 2 permit(8)(9)!定义访问控制列表!Router(config)ip nat inside source list 2 pool xiaoshou!使用访问控制列表完成地址映射
考题
Interface ge-0/0/2.0 of your device is attached to the Internet and is configured with an IP address and network mask of 71.33.252.17/24. A Web server with IP address 10.20.20.1 is running an HTTP service on TCP port 8080. The Web server is attached to the ge-0/0/0.0 interface of your device. You must use NAT to make the Web server reachable from the Internet using port translation.Which type of NAT must you configure?（）A. source NAT with address shiftingB. pool-based source NATC. static destination NATD. pool-based destination NAT
考题
An administrator types in the command router ospf 1 and receives the er ror message: "OSPF process 1 cannot start." (Output is omitted.) What should be done to correctly set up OSPF?()
A. Ensure that an interface has been configured with an IP addressB. Ensure that IP classless is enabledC. Ensure that the interfaces can ping their directly connected neighborsD. Ensure that an interface has been configured with an IP address and is up
考题
TestKing has 25 computers and decides to connect the network to the Internet.TestKing would like for all of the computers to have access to the Internet at the same time, but TestKing only has four usable publicly routable IP addresses.What should be configured on the router so that all computers can connect to the Internet simultaneously?（）A. Static NATB. Global NATC. Dynamic NATD. Static NAT with ACLsE. Dynamic NAT with overload
考题
Refer to the exhibit. What command sequence will enable PAT from the inside to outside network?()
A.(config) ip nat pool isp-net 1.2.4.2 netmask 255.255.255.0 overloadB.(config-if) ip nat outside overloadC.(config) ip nat inside source list 1 interface ethernet1 overloadD.(config-if) ip nat inside overload
考题
Refer to the exhibit. Which command would allow the translations to be created on the router?()
A.ip nat pool mynats 1.1.128.1 1.1.135.254 prefix-length 19B.ip nat outside mynats 1.1.128.1 1.1.135.254 prefix-length 19C.ip nat pool mynats 1.1.128.1 1.1.135.254 prefix-length 18D.ip nat outside mynats 1.1.128.1 1.1.135.254 prefix-length 18
考题
路由器配置中，创建一个名字为cisco含有30个地址的动态NAT池的命令是（）。A、ip nat pool cisco 171.16.10.65 171.16.10.94 net 255.255.255.240B、ip nat pool cisco 171.16.10.65 171.16.10.94 net 255.255.255.224C、ip nat pool CISCO 171.16.10.65 171.16.10.94 net 255.255.255.224D、ip nat pool cisco 171.16.10.1 171.16.10.254 net 255.255.255.0
考题
What is the function of the Cisco IOS command ip nat inside source static 10.1.1.5 172.35.16.5（）。A、It creates a global address pool for all outside NAT transactionsB、It establishes a dynamic address pool for an inside static addressC、It creates dynamic source translations for all inside local PAT transactionsD、It creates a one-to-one mapping between an inside local address and an inside global addressE、It maps one inside source address to a range of outside global addresses
考题
Which of the following commands will remove all dynamic entries for a router’s NAT table？（）A、clear nat translationsB、clear ip nat translations*C、clear ip nat statisticsD、clear ip nat transactions*E、clear ip nat translationsF、clear ip nat translations all
考题
What is the function of the Cisco IOS command ip nat inside source static 10.1.1.5 172.35.16.5？（）A、It creates a global address pool for all outside NAT transactions.B、It establishes a dynamic address pool for an inside static address.C、It creates dynamic source translations for all inside local PAT transactions.D、It creates a one-to-one mapping between an inside local address and an inside global address.E、It maps one inside source address to a range of outside global addresses.
考题
A Cisco router has been configured with the following command:IP nat pool nat-test 192.168.6.10 192.168.6.20 netmask 255.255.255.0his is an example of what type of NAT?（）A、Static NATB、Dynamic NATC、Dynamic NAT with overloadD、Port Address TranslationE、None of the above
考题
Interface ge-0/0/2.0 of your device is attached to the Internet and is configured with an IP address and network mask of 71.33.252.17/24. A Web server with IP address 10.20.20.1 is running an HTTP service on TCP port 8080. The Web server is attached to the ge-0/0/0.0 interface of your device. You must use NAT to make the Web server reachable from the Internet using port translation. Which type of NAT must you configure?（）A、source NAT with address shiftingB、pool-based source NATC、static destination NATD、pool-based destination NAT
考题
Interface ge-0/0/2.0 of your device is attached to the Internet and is configured with an IP address andnetwork mask of 71.33.252.17/24. A webserver with IP address 10.20.20.1 isrunning an HTTP service on TCP port 8080. The webserver is attached to the ge-0/0/0.0 interface of yourdevice. You must use NAT to make the webserver reachable from the Internet using port translation.Which type of NAT must you configure？（）A、source NAT with address shiftingB、pool-based source NATC、static destination NATD、pool-based destination NAT
考题
TestKing has 25 computers and decides to connect the network to the Internet.TestKing would like for all of the computers to have access to the Internet at the same time, but TestKing only has four usable publicly routable IP addresses.What should be configured on the router so that all computers can connect to the Internet simultaneously?（）A、Static NATB、Global NATC、Dynamic NATD、Static NAT with ACLsE、Dynamic NAT with overload
考题
The Frame Relay network in the diagram is not functioning properly. What is the cause of the problem?（）A、The Gallant router has the wrong LMI type configuredB、Inverse ARP is providing the wrong PVC information to the Gallant routerC、The S3 interface of the Steele router has been configured with the frame-relay encapsulation ietf commandD、The frame-relay map statement in the Attalla router for the PVC to Steele is not correctE、The IP address on the serial interface of the Attalla router is configured incorrectly
考题
You have just installed a new web server on the Testking network. You are required to ensure that the web server is accessible from the Internet. The network uses private addressing, so an IP-to-registered address mapping is required.To do this, you enter the following command:TestKing(config)# ip nat inside source static 192.168.2.1 198.18.1.254 You unsuccessfully try to ping the Internet from a PC host on the LAN. During the troubleshooting process, you enter the "show ip nat translations" command but the output is blank. What is the most likely cause of the problem?（）A、The keyword overload is missing from the command.B、The NAT pool must be defined first.C、An access list must be defined to create static NAT translations.D、The interfaces must be configured for NAT.E、None of the above
考题
Router R1 exists in an Enterprise that uses EIGRP as its routing protocol. The show ip route command output on router R1 lists the following phrase: "Gateway of last resort is 1.1.1.1 to network 2.0.0.0". Whic h of the following is most likely to have caused this output to occur on R1?（）A、R1 has been configured with an ip default- network 2.0.0.0 command.B、R1 has been configured with an ip route 0.0.0.0 0.0.0.0 1.1.1.1 command.C、R1 has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.D、Another router has been configured with an ip default - network 2.0.0.0 command.E、Another router has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.
考题
Which type of source NAT is configured in the exhibit？（） [edit security nat destination] user@host# show pool A { address 10.1.10.5/32； } rule-set 1 { from zone untrust； rule 1A { match { destination-address 100.0.0.1/32； } then { destination-nat pool A； } } }A、static destination NATB、static source NATC、pool-based destination NAT without PATD、pool-based destination NAT with PAT
考题
Which type of source NAT is configured in the exhibit？（） [edit security nat source] user@host# show rule-set 1 { from interface ge-0/0/2.0； to zone untrust； rule 1A {match { destination-address 1.1.70.0/24； } then { source-nat interface； } } }A、interface-based source NATB、static source NATC、pool-based source NAT with PATD、pool-based source NAT without PAT
考题
单选题An administrator types in the command router ospf 1 and receives the er ror message: "OSPF process 1 cannot start." (Output is omitted.) What should be done to correctly set up OSPF？（）A
Ensure that an interface has been configured with an IP addressB
Ensure that IP classless is enabledC
Ensure that the interfaces can ping their directly connected neighborsD
Ensure that an interface has been configured with an IP address and is up
考题
单选题What is the function of the Cisco IOS command ip nat inside source static 10.1.1.5 172.35.16.5？（）A
It creates a global address pool for all outside NAT transactions.B
It establishes a dynamic address pool for an inside static address.C
It creates dynamic source translations for all inside local PAT transactions.D
It creates a one-to-one mapping between an inside local address and an inside global address.E
It maps one inside source address to a range of outside global addresses.
考题
单选题Which of the following commands will remove all dynamic entries for a router’s NAT table？（）A
clear nat translationsB
clear ip nat translations*C
clear ip nat statisticsD
clear ip nat transactions*E
clear ip nat translationsF
clear ip nat translations all
考题
单选题路由器配置中，创建一个名字为cisco含有30个地址的动态NAT池的命令是（）。A
ip nat pool cisco 171.16.10.65 171.16.10.94 net 255.255.255.240B
ip nat pool cisco 171.16.10.65 171.16.10.94 net 255.255.255.224C
ip nat pool CISCO 171.16.10.65 171.16.10.94 net 255.255.255.224D
ip nat pool cisco 171.16.10.1 171.16.10.254 net 255.255.255.0
考题
单选题What is the function of the Cisco IOS command ip nat inside source static 10.1.1.5 172.35.16.5（）。A
It creates a global address pool for all outside NAT transactionsB
It establishes a dynamic address pool for an inside static addressC
It creates dynamic source translations for all inside local PAT transactionsD
It creates a one-to-one mapping between an inside local address and an inside global addressE
It maps one inside source address to a range of outside global addresses
考题
单选题A Cisco router has been configured with the following command:IP nat pool nat-test 192.168.6.10 192.168.6.20 netmask 255.255.255.0his is an example of what type of NAT?（）A
Static NATB
Dynamic NATC
Dynamic NAT with overloadD
Port Address TranslationE
None of the above
考题
单选题TestKing has 25 computers and decides to connect the network to the Internet.TestKing would like for all of the computers to have access to the Internet at the same time, but TestKing only has four usable publicly routable IP addresses.What should be configured on the router so that all computers can connect to the Internet simultaneously?（）A
Static NATB
Global NATC
Dynamic NATD
Static NAT with ACLsE
Dynamic NAT with overload
考题
单选题Which type of source NAT is configured in the exhibit？（） [edit security nat destination] user@host# show pool A { address 10.1.10.5/32； } rule-set 1 { from zone untrust； rule 1A { match { destination-address 100.0.0.1/32； } then { destination-nat pool A； } } }A
static destination NATB
static source NATC
pool-based destination NAT without PATD
pool-based destination NAT with PAT
热门标签
最新试卷
