网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
Refer to the exhibit. Which command would allow the translations to be created on the router?()
A.ip nat pool mynats 1.1.128.1 1.1.135.254 prefix-length 19
B.ip nat outside mynats 1.1.128.1 1.1.135.254 prefix-length 19
C.ip nat pool mynats 1.1.128.1 1.1.135.254 prefix-length 18
D.ip nat outside mynats 1.1.128.1 1.1.135.254 prefix-length 18
参考答案
更多 “ Refer to the exhibit. Which command would allow the translations to be created on the router?() A.ip nat pool mynats 1.1.128.1 1.1.135.254 prefix-length 19B.ip nat outside mynats 1.1.128.1 1.1.135.254 prefix-length 19C.ip nat pool mynats 1.1.128.1 1.1.135.254 prefix-length 18D.ip nat outside mynats 1.1.128.1 1.1.135.254 prefix-length 18 ” 相关考题
考题
Refer to the exhibit. The routing protocols EIGRP and OSPF have been configured as indicated in the exhibit. Given the partial configuration of router R2, which network will be present in th e routing table of R4?（）A. Network BB. Network A and Network BC. Network AD. neither Network A nor Network B
考题
Refer to the exhibit. Which statement is co rrect regarding the router configuration shown? ()
A. The router will rebroadcast any DHCP requests received by this interface out to all interfaces included in the ip helper - address commands.B. The router will rebroadcast any UDP broadcasts received by this interface out to all interfaces included in the ip helper - address commands.C. The router will unicast any DHCP requests received by this interface out to all addresses included in the ip helper - address commands.D. This configuration will not do anything because the ip helper - address command needs to also be applied to the 192.168.23.1 IP address.
考题
Refer to the exhibit. What must be done on router RTA to ensure that EIGRP works effectively in a Frame Relay multipoint environment?()
A. Issue the command bandwidth 224 on the physical interface.B. Issue the command bandwidth 56 on the physical interface.C. Issue the command bandwidth 224 on each subinterface.D. Issue the command bandwidth 56 on each subinterface.
考题
Refer to the exhibit. Which interoperability technique implemented on the dual - stack routers would allow connectivity between IPv6 sites across automatic created tunnels using the 2002::/16 prefix? （）A. Dual StackB. NAT - PTC. 6to4 tunnelD. GRE tunnelE. ISATAP tunnel
考题
Refer to the exhibit. OSPF has been configured on all routers in the network. However, router R1 does not receive a default route to router R2 as in tended. Which configuration change would ensure that R1 would receive a default route from R2? （）A. Add the area 1 stub command on routers R1.B. Add the always keyword to the default - information originate configuration command on router R2.C. Remov e the default information originate configuration command from router R2 and place it on router R1.D. Add the ip route 5.0.0.0 255.255.255.0 0.0.0.0 command to router R2.
考题
Refer to the exhibit. Which command would verify if PBR reacts to packets sourced from 172.16.0.0／16?()
A. show ip routeB. show policy - mapC. show access - listsD. show route - map
考题
Refer to the exhibit. Which two Cisco IOS commands on R2 would verify its OSPF neighbor relationships?()
A.show ip ospfB.show ip ospf interfaceC.show ip ospf neighborD.show ip ospf databaseE.show ip ospf statisticsF.show running - config begin router ospf
考题
Refer to the exhibit. Router B is performing bidirectional redistribution between EIGRP an d OSPF.The network 10.100.1.0/24 should not be reachable from the 10.100.9.0/24 network. However, it needs to be reachable from any network within the EIGRP domain. All other networks should be seen in both domains. Which change to router B would accom plish these goals?（）A. Under the EIGRP process, insert the distribute - list block_net_1 out ospf 1 command.B. Under the OSPF process, insert the distribute - list block_net_1 in serial1/0 command.C. Under the EIGRP process, insert the distribute - list block_net_1 in serial1/0 command.D. Under the OSPF process, insert the distribute - list block_net_1 out eigrp 1 command.
考题
Refer to the exhibit. Which statement about dynamic routing protocols for this network is true? ()
A.No dynamic interior routing protocol can summarize as shownB.Unless configured otherwise, EIGRP would automatically summa rize the prefixes as shown in the exhibitC.With this IP addressing scheme, EIGRP can be manually configured to summarize prefixes at the specified summarization pointsD.The IP address design lends itself to OSPF Each summarizing router would be an ABR, summarizing to the next area in the address hierarchy
考题
Refer to the exhibit. ROUTE Enterprises has many stub networks in their enterprise network, such as router B and its associated network. EIGRP is to be implemented on router A so that neither the prefix for the S/0/0/0 interface nor the prefixes from router B appear in the routing tables for the router in the enterprise network. Which action will accomplish this goal?（）A. Declare router B a stub router using the eigrp stub command.B. Use the passive - interface command for interface Serial0/0/0.C. Use a mask with the network command to exclude interface Serial0/0/0.D. Implement a distribute list to exclude the link prefix from the routi ng updates.
考题
Refer to the exhibit. Which th ree commands should be used on router B1 to redistribute the EIGRP AS 10 routes into RIP?()
A. router ripB. router eigrp 10C. redistribute eigrp 10D. redistribute ripE. default - metric 10000 100 255 1 1500F. default - metric 5
考题
Refer to the exhibit. Which st atement is true?()
A. Router RTA is the BDRB. Router RTA is directly connected to interface 192.168.45.1C. Neighbor 192.168.45.1 has changed its OSPF priority numberD. Router RTA and neighbor 192.168.45.2 are exchanging OSPF LSAs
考题
After executing the "show host" command, which of the information below would you see?()
A. The IP addresses of workstations allowed gain access to the router via an access listB. Permanent name-to-address mappings created using the ip host command.C. Temporary and permanent DNS entries.D. The names of the routers created using the hostname command.E. The length of time of users logged into the router, as well as the duration
考题
Refer to the exhibit. Router R1 is connected to networks 172.1 6.1.0 ／26 and 172.16.1.64 ／27. On the basis of the partial output in the exhibit, which statement is true? ()
A. Router R1 will deny the 172.16.1.0/26 route while permitting the 172.16.1.64/27 route to be advertised.B. Router R1 will advertise both rou tes.C. Router R1 should be reconfigured with an ACL instead of an ip prefix - list command.D. Router R1 will deny the 172.16.1.0/27 route while permitting the 172.16.1.0/26 route to be advertised.
考题
Which command would you configure globally on a Cisco router that would allow you to view directly connected Cisco devices?()
A. enable cdpB. cdp enableC. cdp runD. run cdp
考题
Refer to the exhibit. When running OSPF, What would cause router A not to form an adjacency with router B?()
A.The loopback addresses are on different subnetsB.The value of the dead timers on the router are differentC.Route summarization is enabled on both routersD.The process indentifier on router A is different than the process identifier on router B
考题
Refer to the exhibit. When running EIGRP, What is required for RouterA to exchange routing updates with RouterC?（）A、As numbers must be changed to match on all the routers.B、Loopback interface must be configured so a DR is elected.C、The no auto-summary command is needed on Router A and Router C.D、Router B needs to have two network statements, one for each connected network.
考题
Refer to the exhibit. Which statement is correct based on the show login command output shown？（）A、When the router goes into quiet mode， any host is permitted to access the router via Telnet，SSH， and HTTP，since the quiet-mode access list has not been configured.B、The login block-for command is configured to block login hosts for 93 seconds.C、All logins from any sources are blocked for another 193 seconds.D、Three or more login requests have failed within the last 100 seconds.
考题
At which command prompt would you issue the set date command?（）A、[edit chassis]user@router#B、[edit]user@router#C、[edit system] user@router#D、user@router
考题
Which command would you configure globally on a Cisco router that would allow you to view directly connected Cisco devices?（）A、enable cdpB、cdp enableC、cdp runD、run cdp
考题
After executing the "show host" command, which of the information below would you see?（）A、The IP addresses of workstations allowed gain access to the router via an access listB、Permanent name-to-address mappings created using the ip host command.C、Temporary and permanent DNS entries.D、The names of the routers created using the hostname command.E、The length of time of users logged into the router, as well as the duration
考题
Which of the following would need to be implemented on a wireless router to allow network accessbased on a passphrase that the administrator would supply?（）A、WPA-PSK encryptionB、SSID broadcastC、Port forwardingD、MAC filtering
考题
单选题Refer to the exhibit. Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this RouterD?（）A
10.1.1.2B
10.154.154.1C
172.16.5.1D
192.168.5.3
考题
单选题Refer to the exhibit. Which statement is correct based on the show login command output shown？（）A
When the router goes into quiet mode， any host is permitted to access the router via Telnet，SSH， and HTTP，since the quiet-mode access list has not been configured.B
The login block-for command is configured to block login hosts for 93 seconds.C
All logins from any sources are blocked for another 193 seconds.D
Three or more login requests have failed within the last 100 seconds.
考题
单选题At which command prompt would you issue the set date command?（）A
[edit chassis]user@router#B
[edit]user@router#C
[edit system] user@router#D
user@router
考题
多选题Refer to the exhibit. Which three statements accurately describe this GLBP topology？ （Choose three.）（）ARouter A is responsible for answering ARP requests sent to the virtual IP address.BIf Router A becomes unavailable， Router B will forward packets sent to the virtual MAC address of Router ACIf another router were added to this GLBP group， there would be two backup AVGsDRouter B is in GLBP listen state.ERouter A alternately responds to ARP requests with different virtual MAC addresses.FRouter B will transition from blocking state to forwarding state when it becomes the AVG
热门标签
最新试卷
