网友您好, 请在下方输入框内输入要搜索的题目:

题目内容 (请给出正确答案)
Refer to the exhibit. Which st atement is true?()

A. Router RTA is the BDR

B. Router RTA is directly connected to interface 192.168.45.1

C. Neighbor 192.168.45.1 has changed its OSPF priority number

D. Router RTA and neighbor 192.168.45.2 are exchanging OSPF LSAs


参考答案

更多 “ Refer to the exhibit. Which st atement is true?() A. Router RTA is the BDRB. Router RTA is directly connected to interface 192.168.45.1C. Neighbor 192.168.45.1 has changed its OSPF priority numberD. Router RTA and neighbor 192.168.45.2 are exchanging OSPF LSAs ” 相关考题
考题 Refer to the exhibit. Which of the following statements is true? () A. BGP NSF awareness is enabledB. SSO for BGP NSF capability is enabledC. BGP graceful restart awareness is enabledD. 10.11.1.187 is configured as an NSF-capable BGP neighbor

考题 Refer to the exhibit. The routing protocols EIGRP and OSPF have been configured as indicated in the exhibit. Given the partial configuration of router R2, which network will be present in th e routing table of R4?()A. Network BB. Network A and Network BC. Network AD. neither Network A nor Network B

考题 Refer to the exhibit. Which interoperability technique implemented on the dual - stack routers would allow connectivity between IPv6 sites across automatic created tunnels using the 2002::/16 prefix? ()A. Dual StackB. NAT - PTC. 6to4 tunnelD. GRE tunnelE. ISATAP tunnel

考题 Refer to the exhibit. Which command would verify if PBR reacts to packets sourced from 172.16.0.0/16?() A. show ip routeB. show policy - mapC. show access - listsD. show route - map

考题 Refer to the exhibit. Examine the partial configuration and the routing table excerpt. Which routes would be redistributed into OSPF area 1?() A. 10.10.10.16/28 onlyB. 10.10.10.16/28 and 10.10.10.64/26C. 10.10.10.16/28, 10.10.10.64/26, and 172.16.10.0/24D. 10.10.10.64/26 only

考题 Refer to the exhibit. Examine the partial configuration and the routing table excerpt. Which routes would be redistributed into OSPF area 1? () A. 10.10.10.16/28 onlyB. 10.10.10.16/28 and 10.10.10.64/26C. 10.10.10.16/28, 10.10.10 .64/26, and 172.16.10.0/24D. 10.10.10.64/26 only

考题 Refer to the exhibit. Which th ree commands should be used on router B1 to redistribute the EIGRP AS 10 routes into RIP?() A. router ripB. router eigrp 10C. redistribute eigrp 10D. redistribute ripE. default - metric 10000 100 255 1 1500F. default - metric 5

考题 Refer to the exhibit. The partial configuration for an OSPF ASBR and an Area 0 ABR is shown. Assume the OSPF configurations throughout the network are operable. Which statement about these configurations is true? ()A. The ASBR route - maps are basically useless, because there are no deny prefix - lists.B. LSA Type 5s wil l not be received by the ABR from the ASBR.C. The OSPF backbone will not learn any RFC 1918 addresses.D. The matched prefix - list addresses will be given a metric of 255, which is essentially unreachable.

考题 Refer to the exhibit. OSPF is running throughout the network. You want to minimize the propagation of LSAs into and out of A rea 1. Which OSPF feature would best achieve this goal? () A. stubB. totally stubbyC. NSSAD. totally NSSA

考题 Refer to the exhibit. Looking at the topology diagram and the partial router configurations shown, which statement is true? () A.The NProuter has two OSPF neighbors in the Full adjacency stateB.The NProuter serial0/0 interface has the OSPF dead timer set to 10 secondsC.The NProuter serial0/0 interface has been configured with an OSPF network type of pointtopointD.The 10.1.1.1 and 10.1.1.2 routers are not using the default OSPF dead and hello timers settingE.The Mismatched error is caus ed by the expiration of the OSPF timers

考题 Refer to the exhibit. What three statements are true about the IS - IS configuration?() A.The router is in area 49.0001.0002B.The router acts as a Level 1 - 2 routerC.CLNS routing is enable d for the routerD.The router has a system ID of 0003.0004E.The interfaces have a functional IS - IS configurationF.The network service access point selector (NSEL) byte has a value of 0

考题 Refer to the exhibit. Which statement is true? () A. Only traffic with a destination from 10.10.0.0/19 will be permitted.B. Router RAR1 will accept only route 10.10.0.0/19 from its BGP neighbor.C. Only traffic going to 10.10.0.0/19 will be permitted.D. Router RAR1 will send only route 10.10.0.0/19 to its BGP neighbor.

考题 Refer to the exhibit. Which two statement s are correct?() A. All the routes were redistributed into BGP from an IGPB. All the routes were originated by BGP with the network commandC. All six routes will be installed in the routing tableD. Four routes will be installed in the routing ta bleE. Two routes will be installed in the routing table

考题 Refer to the exhibit. Which two statements are true about the partial configuration that is provided.() A. The peer group shortens the EBGP configurationB. The peer group shortens the IBGP configurationC. All the configured neighbors are in autonomous system 100D. Three AS - path filters are applied to each BGP neighborE. Only the outgoing filters are applied to BGP updates

考题 Refer to the exhibit. Which statement is true about the configuration? () A. RTA will not establish an OSPF adjacency w ith RTBB. RTA will send OSPF hello packets, but will not send OSPF updatesC. RTA will not accept OSPF hello packets from RTBD. RTA will send OSPF updates, but will not establish an adjacency with RTB

考题 Refer to the exhibit. Which subnet mask will place all hosts on Network B in the same subnet with the least amount of wasted addresses?() A.255.255.255.0B.255.255.254.0C.255.255.252.0D.255.255.248.0

考题 Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?() A.data link layerB.application layerC.access layerD.session layerE.network layer

考题 Refer to the exhibit. Which statement is true?() A.The Fa0/11 role confirms that SwitchA is the root bridge for VLAN 20.B.VLAN 20 is running the Per VLAN Spanning Tree Protocol.C.The MAC address of the root bridge is 0017.596d.1580.D.SwitchA is not the root bridge, because not all of the interface roles are designated.

考题 Refer to the exhibit. Which value will be configured for Default Gateway of the Local Area Connection?() A.10.0.0.0B.10.0.0.254C.192.223.129.0D.192.223.129.254

考题 Refer to the exhibit. The DHCP configuration that is shown is configured on a Cisco router. Whichstatement is true?()A、The router will distribute IP addresses from pool 1 until its addresses are exhausted. Then therouter will begin distributing addresses from pool 2B、The configuration is invalid because the DHCP options are global configuration commandsC、The configuration is incomplete until the DHCP pools are bound to the appropriate interface orinterfacesD、The router will choose which pool to use based upon the interface the DHCP request wasreceived on

考题 Which of the following statements are true?() A、 The equals() method determines if reference values refer to the same object.B、 The == operator determines if the contents and type of two separate objects match.C、 The equals() method returns true only when the contents of two objects match.D、 The class File overrides equals() to return true if the contents and type of two separate objects match.

考题 多选题Refer to the exhibit. Which three statements are true about trust boundaries in the campus network?  (Choose three.)()AA device is trusted if it correctly classifies packets.BA device is trusted if it correctly declassifies packets.CThe outermost trusted devices represent the trust boundary.DClassification and marking occur using 802.1ab QoS bits before reaching the trust boundary.ENetwork trust boundaries are automatically configured in IOS version 12.3 and later.FFor scalability, classification should be done as close to the edge as possible.

考题 多选题Refer to the exhibit. Which two statements are correct?()AAll six routes will be installed in the routing tableBTwo routes will be installed in the routing tableCFour routes will be installed in the routing tableDAll the routes were redistributed into BGP from an IGPEAll the routes were originated by BGP with the network command

考题 单选题Refer to the exhibit. Which statement is true about a voice VLAN?()A  Physically the voice network and the data network are separate.B  The voice traffic will normally be on a different IP subnet than will the data traffic.C  End user intervention is necessary to place the phone into the proper VLAN.D  The same security policy should be implemented for both voice and data traffic.E  The data VLAN must be configured as the native VLAN.

考题 单选题Refer to the exhibit. The DHCP configuration that is shown is configured on a Cisco router. Whichstatement is true?()A The router will distribute IP addresses from pool 1 until its addresses are exhausted. Then therouter will begin distributing addresses from pool 2B The configuration is invalid because the DHCP options are global configuration commandsC The configuration is incomplete until the DHCP pools are bound to the appropriate interface orinterfacesD The router will choose which pool to use based upon the interface the DHCP request wasreceived on

考题 单选题Refer to the exhibit. Which statement is true about a voice VLAN?()A Physically the voice network and the data network are separateB The voice traffic will normally be on a different IP subnet than will the data trafficC End user intervention is necessary to place the phone into the proper VLAND The same security policy should be implemented for both voice and data trafficE The data VLAN must be configured as the native VLAN

考题 多选题Refer to the exhibit. Which two statements are true about the partial configuration that is shown?()AHosts connected to the FastEthernet0/1 interface will not receive DHCP replies from the routerBThe first DHCP client to connect to the FastEthernet 0/1 interface will receive the IP address10.10.0.1CThe first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address10.0.0.1DDHCP requests received on the FastEthernet 0/1 interface will be forwarded to 10.0.0.2EThe first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address10.0.0.6