网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
Refer to the exhibit. Which value will be configured for Default Gateway of the Local Area Connection?()
A.10.0.0.0
B.10.0.0.254
C.192.223.129.0
D.192.223.129.254
参考答案
更多 “ Refer to the exhibit. Which value will be configured for Default Gateway of the Local Area Connection?() A.10.0.0.0B.10.0.0.254C.192.223.129.0D.192.223.129.254 ” 相关考题
考题
Refer to the exhibit. Which of the following statements is true? ()
A. BGP NSF awareness is enabledB. SSO for BGP NSF capability is enabledC. BGP graceful restart awareness is enabledD. 10.11.1.187 is configured as an NSF-capable BGP neighbor
考题
Refer to the exhibit. The routing protocols EIGRP and OSPF have been configured as indicated in the exhibit. Given the partial configuration of router R2, which network will be present in th e routing table of R4?（）A. Network BB. Network A and Network BC. Network AD. neither Network A nor Network B
考题
Refer to the exhibit. OSPF has been configured on all routers in the network. However, router R1 does not receive a default route to router R2 as in tended. Which configuration change would ensure that R1 would receive a default route from R2? （）A. Add the area 1 stub command on routers R1.B. Add the always keyword to the default - information originate configuration command on router R2.C. Remov e the default information originate configuration command from router R2 and place it on router R1.D. Add the ip route 5.0.0.0 255.255.255.0 0.0.0.0 command to router R2.
考题
Refer to the exhibit. Router C was configured so that it could form an adja cency with three OSPF neighbors, one connected to each of its three physical interfaces. Which statement is correct about router C?（）A. It is configured and functioning correctly as an OSPF internal router.B. It is configured and functioning correc tly as an ABR attached to stub area 4.C. It is configured and functioning correctly as an ASBR attached to external area 4.D. It is configured and functioning correctly as an ABR attached to totally stubby area 4.E. It is not configured correctly to function as specified.
考题
Refer to the exhibit. Which statement about dynamic routing protocols for this network is true? ()
A.No dynamic interior routing protocol can summarize as shownB.Unless configured otherwise, EIGRP would automatically summa rize the prefixes as shown in the exhibitC.With this IP addressing scheme, EIGRP can be manually configured to summarize prefixes at the specified summarization pointsD.The IP address design lends itself to OSPF Each summarizing router would be an ABR, summarizing to the next area in the address hierarchy
考题
Refer to the exhibit. A company would prefer all Internet - bound OSPF routed traffic to use ISP ABC with ISP DEF as a backup. As the network consultant, what three configuration changes might you make?（）A. The default -information originate command should be configured on router B1 and B4.B. The default -information originate command should be configured on router B2 and B3.C. If the metric value for ISP ABC is set at the default, the I SP DEF metric value should be set to 1.D. If the metric value for ISP ABC is set at the default, the ISP DEF metric value should be set to 25.E. The metric type value should be set to type 1.F. The metric type value should be set to type 2.
考题
Refer to the above exhibit. Why is the 140.140.0.0 network not used as the gateway of last resort even though it is configured first?()
A.The last default - network statement will always be preferred.B.A route to the 140.140.0.0 network does not exist in the routing table.C.Default - network selection will always prefer the statement with the lowest IP address.D.A router will load balance across multiple default - networks; repeatedly issuing the show ip route command would show the gateway of last resort changing between the two networks.
考题
Refer to the exhibit. ROUTE.com has just implemented this EIGRP network. A network administrator came to you for advice while trying to implement load balancing across part of their EIGRP network. If the variance value is configured as 2 on all routers and all o ther metric and K values are configured to their default values, traffic from the Internet to the data center will be load balanced across how many paths? （）A. 1B. 2C. 3D. 4E. 5
考题
Refer to the exhibit. What is required to complete the IPv6 routing configurations shown?()
A. Interface authentication must be configuredB. The routing processes must be configured with an area IDC. IP unicast routing must be enabledD. IPv4 ad dresses must be applied to the interfaces
考题
Refer to the exhibit. Which statement is true about the 6.6.6.0／24 prefix?()
A. The command neighbor send -community is configured on BGP neighbor 10.10.23.3.B. If another path advertises the 6.6.6.0/24 path and has the default local preference, that path is more preferred.C. Route 6.6.6.0/24 is learned by an IBGP peer.D. The route 10.10.23.3 is not being advertised to other BGP neighbors.
考题
Refer to the exhibit. OSPF has been configured on all routers in the network and Area 1 has been configured as a NSSA. Which statement is true about the NSSA Area 1?()
A. Only redistributed RIP routes will appear in Area 1. They will be advertised via t ype 7 LSAsB. No redistributed routes can appear in Area 1, only summary routesC. Redistributed RIP and IGRP routes will appear in Area 1. They will be advertised via type 5 LSAsD. Only redistributed IGRP routes will appear in Area 1. They will be advertised via type 7 LSAs
考题
Into which two types of areas would an area border router (ABR) inject a default route?()
A. stubB. the autonomous system of an exte rior gateway protocol (EGP)C. NSSAD. totally stubbyE. the autonomous system of a different interior gateway protocol (IGP)F. area 0
考题
Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?()
A.data link layerB.application layerC.access layerD.session layerE.network layer
考题
Refer to the exhibit. The output that is shown is generated at a switch. Which three of these statements are true? （）A、All ports will be in a state of discarding, learning, or forwarding.B、Thirty VLANs have been configured on this switch.C、The bridge priority is lower than the default value for spanning tree.D、All interfaces that are shown are on shared media.E、All designated ports are in a forwarding state.F、The switch must be the root bridge for all VLANs on this switch.
考题
A computer is able to ping other devices on the same network but is unable to ping devices onanother network. Which of the following needs to be configured?（）A、DNS primary serverB、Host routeC、Proxy ARPD、Default gateway
考题
An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location？ （）A、The switch must be configured with an IP address,subnet mask,and default gateway.B、The switch must be connected to a router over a VLAN trunk.C、The switch must be reachable through a port connected to its management VLAN.D、The switch console port must be connected to the Ethernet LAN.E、The switch management VLAN must be created and have a membership of at least one switch port.F、The switch must be fully configured as an SNMP agent.
考题
Into which two types of areas would an area border router (ABR) inject a default route?（）A、stubB、the autonomous system of an exte rior gateway protocol (EGP)C、NSSAD、totally stubbyE、the autonomous system of a different interior gateway protocol (IGP)F、area 0
考题
An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location? （）A、The switch must be configured with an IP address, subnet mask, and default gateway.B、The switch must be connected to a router over a VLAN trunk.C、The switch must be reachable through a port connected to its management VLAN.D、The switch console port must be connected to the Ethernet LAN.E、The switch management VLAN must be created and have a membership of at least one switch
考题
Cat6500（config）# router ospf 1 Cat6500（config-router）# network 0.0.0.0 255.255.255.255 area 0 Cat6500（config-router）# nsf Cat6500（config-router）#end Refer to the exhibit. The configuration is used to enable nonstop forwarding for OSPF on a Catalyst 6500 Series Switch with redundant supervisor engines. The default CEF configuration is unchanged. After testing， user traffic is interrupted and NSF is not operational. What is the most likely reason？ （）A、CEF was not properly configured.B、OSPF was not properly configured for graceful restart.C、Stateful switchover was not correctly configured.D、NSF for OSPF is only supported in area 0.
考题
Your network contains a server named Server1. Server1 runs Windows Server 2008 R2 and has a single network connection. The connection is configured to use a default gateway address of 10.0.0.1.The default gateway has a metric value of 100.You configure a second default gateway that uses an address of 10.0.0.2.You need to ensure that 10.0.0.2 is only used as the default gateway if 10.0.0.1 is unreachable. What should you do？（）A、For the interface, set the interface metric to 100.B、For the 10.0.0.2 gateway, set the metric to 50.C、For the 10.0.0.2 gateway, set the metric to 200.D、For the 10.0.0.1 gateway and the 10.0.0.2 gateway, enable automatic metric.
考题
单选题Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?（）A
data link layerB
application layerC
access layerD
session layerE
network layer
考题
单选题The database is running in ARCHIVELOG mode and the FORMAT option is not configured in RMAN for disk backups. You configured the flash recovery area location and size by using the DB_RECOVERY_FILE_DEST and DB_RECOVERY_FILE_DEST_SIZE initialization parameters. Which statement is correct in this scenario？（）A
If the FORMAT option to the RMAN BACKUP command is specified， then RMAN creates backup pieces and image copies in the flash recovery area with names in the Oracle Managed Files （OMF） format.B
If any local destinations for LOG_ARCHIVE_DEST_n are set， then archived redo logs are stored in these destinations as well as in the flash recovery area.C
If the flash recovery area location is configured using the DB_RECOVERY_FILE_DEST initialization parameter， then the RMAN backup of Oracle managed datafiles （OMF） only will go to the flash recovery area by default.D
If no other destination is configured for recovery files， then RMAN places the control file autobackups in the flash recovery area by default.
考题
多选题Into which two types of areas would an area border router (ABR) inject a default route?（）AstubBthe autonomous system of an exte rior gateway protocol (EGP)CNSSADtotally stubbyEthe autonomous system of a different interior gateway protocol (IGP)Farea 0
考题
多选题An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location？ （）AThe switch must be configured with an IP address,subnet mask,and default gateway.BThe switch must be connected to a router over a VLAN trunk.CThe switch must be reachable through a port connected to its management VLAN.DThe switch console port must be connected to the Ethernet LAN.EThe switch management VLAN must be created and have a membership of at least one switch port.FThe switch must be fully configured as an SNMP agent.
考题
多选题An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location? （）AThe switch must be configured with an IP address, subnet mask, and default gateway.BThe switch must be connected to a router over a VLAN trunk.CThe switch must be reachable through a port connected to its management VLAN.DThe switch console port must be connected to the Ethernet LAN.EThe switch management VLAN must be created and have a membership of at least one switch
考题
单选题You have a server named Server2 that runs Windows Server 2003 Service Pack 2 (SP2). The server has two network connections named Local Area Connection and Internet Connection.You configure network address translation (NAT) on Server2 as shown in the exhibit. (Click the Exhibit button.) You configure all client computers to use Server2 as their default gateway.Users report that they cannot connect to the Internet. You successfully connect to the Internet from Server2.You need to ensure that client computers can access Internet resources. What should you do?（）A
Change the Internet Connection interface type to Basic firewall only. B
Change the Internet Connection interface type to Private interface connected to private network. C
Add Local Area Connection as a new interface for the NAT protocol and set the interface as a Public interface connected to the Internet. D
Add Local Area Connection as a new interface for the NAT protocol and set the new interface as a Private interface connected to private network.
考题
单选题Refer to the exhibit. Which statement is true about the 6.6.6.0/24 prefix？（）A
If another path advertises the 6.6.6.0/24 path and has the default local preference， that path is more preferredB
The command neighbor send-community is configured on BGP neighbor 10.10.23.3C
The route 10.10.23.3 is not being advertised to other BGP neighborsD
Route 6.6.6.0/24 is learned by an IBGP peer
热门标签
最新试卷
