网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
Refer to the exhibit. Looking at the topology diagram and the partial router configurations shown, which statement is true? ()
A.The NProuter has two OSPF neighbors in the "Full" adjacency state
B.The NProuter serial0/0 interface has the OSPF dead timer set to 10 seconds
C.The NProuter serial0/0 interface has been configured with an OSPF network type of "pointtopoint"
D.The 10.1.1.1 and 10.1.1.2 routers are not using the default OSPF dead and hello timers setting
E.The "Mismatched" error is caus ed by the expiration of the OSPF timers
参考答案
更多 “ Refer to the exhibit. Looking at the topology diagram and the partial router configurations shown, which statement is true? () A.The NProuter has two OSPF neighbors in the Full adjacency stateB.The NProuter serial0/0 interface has the OSPF dead timer set to 10 secondsC.The NProuter serial0/0 interface has been configured with an OSPF network type of pointtopointD.The 10.1.1.1 and 10.1.1.2 routers are not using the default OSPF dead and hello timers settingE.The Mismatched error is caus ed by the expiration of the OSPF timers ” 相关考题
考题
Refer to the exhibit. Which two statements are true about the partial configuration that is shown? ()
A. The first DHCP client to connect to the FastEthernet 0/1 interface will receive the IP address 10.10.0.1.B. DHCP requests received on the FastEthernet 0/1 interface will be forwarded to 10.0.0.2.C. The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP a ddress 10.0.0.1D. The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address 10.0.0.6.E. Hosts connected to the FastEthernet0/1 interface will not receive DHCP replies from the router.
考题
Refer to the exhibit. The routing protocols EIGRP and OSPF have been configured as indicated in the exhibit. Given the partial configuration of router R2, which network will be present in th e routing table of R4?（）A. Network BB. Network A and Network BC. Network AD. neither Network A nor Network B
考题
Refer to the exhibit. Which statement is co rrect regarding the router configuration shown? ()
A. The router will rebroadcast any DHCP requests received by this interface out to all interfaces included in the ip helper - address commands.B. The router will rebroadcast any UDP broadcasts received by this interface out to all interfaces included in the ip helper - address commands.C. The router will unicast any DHCP requests received by this interface out to all addresses included in the ip helper - address commands.D. This configuration will not do anything because the ip helper - address command needs to also be applied to the 192.168.23.1 IP address.
考题
Refer to the exhibit. Which statement about dynamic routing protocols for this network is true? ()
A.No dynamic interior routing protocol can summarize as shownB.Unless configured otherwise, EIGRP would automatically summa rize the prefixes as shown in the exhibitC.With this IP addressing scheme, EIGRP can be manually configured to summarize prefixes at the specified summarization pointsD.The IP address design lends itself to OSPF Each summarizing router would be an ABR, summarizing to the next area in the address hierarchy
考题
Refer to the exhibit. The partial configuration for an OSPF ASBR and an Area 0 ABR is shown. Assume the OSPF configurations throughout the network are operable. Which statement about these configurations is true? （）A. The ASBR route - maps are basically useless, because there are no deny prefix - lists.B. LSA Type 5s wil l not be received by the ABR from the ASBR.C. The OSPF backbone will not learn any RFC 1918 addresses.D. The matched prefix - list addresses will be given a metric of 255, which is essentially unreachable.
考题
Refer to the exhibit. A partial routing configuration is shown. Complete the configuration so that only the default - network is redistributed from EIGRP 190 into EIGRP 212. Which ACL statement completes the configuration correctly? （）A. access - list 100 permit ip 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0 .0B. access - list 100 permit ip host 0.0.0.0 anyC. access - list 100 permit ip any host 0.0.0.0D. A default -network cannot be redistributed between routing processes.
考题
Refer to the exhibit. Routing updates for the 192.168.1.0 network are being received from all three neighbors. Which statement is correct regarding the result of the con figuration shown? ()
A. The router will prefer the next hop of 172.16.1.1 for packets destined for the 192.168.1.0 network.B. The router will prefer the next hop of 172.26.1.1 for packets destined for the 192.168.1.0 network.C. The router will adve rtise the 192.168.1.0 network only to 172.30.1.1.D. The router will advertise the 192.168.1.0 network only to 172.26.1.1.E. The router will prefer the next hop of 172.26.1.1 for packets except those destined for the 192.168.1.0 network.
考题
Refer to the exhibit. What is required to complete the IPv6 routing configurations shown?()
A. Interface authentication must be configuredB. The routing processes must be configured with an area IDC. IP unicast routing must be enabledD. IPv4 ad dresses must be applied to the interfaces
考题
Refer to the parti al configurations in the exhibit. What address is utilized for DR and BDR identification on Router1?()
A. the serial 1/1 addressB. the serial 2/0 addressC. a randomly generated internal addressD. the configured router - id address
考题
Refer to the exhibit. Which statement is true about the router configuration that is shown ?Select the best response.()
A. Additional DHCP options will be imported from another DHCP server.B. The DHCP server pools need to be bound to an interface to operate.C. This configuration will provide IP configuration information to two different su bnets.D. Additional DCHP option information needs to be imported from another DHCP server.E. If the router hands out all the addresses in pool 1, then it will supply addresses from pool 2.
考题
Refer to the exhibit. Which statement is true? ()
A. Only traffic with a destination from 10.10.0.0/19 will be permitted.B. Router RAR1 will accept only route 10.10.0.0/19 from its BGP neighbor.C. Only traffic going to 10.10.0.0/19 will be permitted.D. Router RAR1 will send only route 10.10.0.0/19 to its BGP neighbor.
考题
Refer to the exhibit. Which two statements are true about the partial configuration that is provided.()
A. The peer group shortens the EBGP configurationB. The peer group shortens the IBGP configurationC. All the configured neighbors are in autonomous system 100D. Three AS - path filters are applied to each BGP neighborE. Only the outgoing filters are applied to BGP updates
考题
Refer to the exhibit. Which st atement is true?()
A. Router RTA is the BDRB. Router RTA is directly connected to interface 192.168.45.1C. Neighbor 192.168.45.1 has changed its OSPF priority numberD. Router RTA and neighbor 192.168.45.2 are exchanging OSPF LSAs
考题
Refer to the exhibit. Which statement is true about the configuration? ()
A. RTA will not establish an OSPF adjacency w ith RTBB. RTA will send OSPF hello packets, but will not send OSPF updatesC. RTA will not accept OSPF hello packets from RTBD. RTA will send OSPF updates, but will not establish an adjacency with RTB
考题
Refer to the exhibit. Router R1 is connected to networks 172.1 6.1.0 ／26 and 172.16.1.64 ／27. On the basis of the partial output in the exhibit, which statement is true? ()
A. Router R1 will deny the 172.16.1.0/26 route while permitting the 172.16.1.64/27 route to be advertised.B. Router R1 will advertise both rou tes.C. Router R1 should be reconfigured with an ACL instead of an ip prefix - list command.D. Router R1 will deny the 172.16.1.0/27 route while permitting the 172.16.1.0/26 route to be advertised.
考题
Refer to the exhibit. A network associate has configured OSPF with the command:City(config-router) network 192.168.12.64 0.0.0.63 area 0After completing the configuration, the associate discovers that not all the interfaces are participating in OSPF. Which three of the interfaces shown in the exhibit will participate in OSPF according to this configuration statement? （）A.FastEthernet0 /0B.FastEthernet0 /1C.Serial0/0D.Serial0/1.102E.Serial0/1.103F.Serial0/1.104
考题
Refer to the diagram. Which three statements describe the router port configuration and the switch port configuration as shown in the topology? ()
A.The Router1 WAN port is configured as a trunking port.B.The Router1 port connected to Switch1 is configured using subinterfaces.C.The Router1 port connected to Switch1 is configured as 10 Mbps.D.The Switch1 port connected to Router1 is configured as a trunking port.E.The Switch1 port connected to Host B is configured as an access port.F.The Switch1 port connected to Hub1 is configured as full duplex.
考题
Refer to the exhibit. Which statement is correct based on the show login command output shown？（）A、When the router goes into quiet mode， any host is permitted to access the router via Telnet，SSH， and HTTP，since the quiet-mode access list has not been configured.B、The login block-for command is configured to block login hosts for 93 seconds.C、All logins from any sources are blocked for another 193 seconds.D、Three or more login requests have failed within the last 100 seconds.
考题
Refer to the exhibit. Which two statements are true about the partial configuration that is shown？（）A、Hosts connected to the FastEthernet0/1 interface will not receive DHCP replies from the routerB、The first DHCP client to connect to the FastEthernet 0/1 interface will receive the IP address10.10.0.1C、The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address10.0.0.1D、DHCP requests received on the FastEthernet 0/1 interface will be forwarded to 10.0.0.2E、The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address10.0.0.6
考题
Refer to the exhibit. The output that is shown is generated at a switch. Which three of these statements are true? （）A、All ports will be in a state of discarding, learning, or forwarding.B、Thirty VLANs have been configured on this switch.C、The bridge priority is lower than the default value for spanning tree.D、All interfaces that are shown are on shared media.E、All designated ports are in a forwarding state.F、The switch must be the root bridge for all VLANs on this switch.
考题
Refer to the exhibit. The DHCP configuration that is shown is configured on a Cisco router. Whichstatement is true？（）A、The router will distribute IP addresses from pool 1 until its addresses are exhausted. Then therouter will begin distributing addresses from pool 2B、The configuration is invalid because the DHCP options are global configuration commandsC、The configuration is incomplete until the DHCP pools are bound to the appropriate interface orinterfacesD、The router will choose which pool to use based upon the interface the DHCP request wasreceived on
考题
单选题Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?（）A
data link layerB
application layerC
access layerD
session layerE
network layer
考题
单选题Refer to the exhibit. Which statement is correct based on the show login command output shown？（）A
When the router goes into quiet mode， any host is permitted to access the router via Telnet，SSH， and HTTP，since the quiet-mode access list has not been configured.B
The login block-for command is configured to block login hosts for 93 seconds.C
All logins from any sources are blocked for another 193 seconds.D
Three or more login requests have failed within the last 100 seconds.
考题
多选题Refer to the router topology shown in the graphic. Assuming that all routers are running OSPF, which statements correctly describe how the routers exchange routing information?（）ADenmark exchanges with Utah, Paris, and Berlin.BUtah exchanges only with Denmark.CBerlin exchanges with Denmark, Utah, and Paris.DParis exchanges only with Denmark.EDenmark exchanges with only Paris and Utah.
考题
单选题Refer to the exhibit. The DHCP configuration that is shown is configured on a Cisco router. Whichstatement is true？（）A
The router will distribute IP addresses from pool 1 until its addresses are exhausted. Then therouter will begin distributing addresses from pool 2B
The configuration is invalid because the DHCP options are global configuration commandsC
The configuration is incomplete until the DHCP pools are bound to the appropriate interface orinterfacesD
The router will choose which pool to use based upon the interface the DHCP request wasreceived on
考题
多选题Refer to the exhibit. Which two statements are true about the partial configuration that is shown？（）AHosts connected to the FastEthernet0/1 interface will not receive DHCP replies from the routerBThe first DHCP client to connect to the FastEthernet 0/1 interface will receive the IP address10.10.0.1CThe first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address10.0.0.1DDHCP requests received on the FastEthernet 0/1 interface will be forwarded to 10.0.0.2EThe first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address10.0.0.6
考题
单选题Refer to the exhibit. Given the DHCP pool configuration shown on Router A, the Cisco IP phone will not boot up in the Teleworker location. What is missing from the Teleworker DHCP pool configuration?（）A
The DHCP pool needs to have an import all statement. B
The DHCP pool is missing an option 150 ip 10.59.138.1 statement.C
The DHCP pool is missing an option 139 ip 10.59.138.1 statementD
The DHCP pool is missing a dns-server 10.59.138.1 statement.
热门标签
最新试卷
