网友您好, 请在下方输入框内输入要搜索的题目:

题目内容 (请给出正确答案)

Under which circumstance will a branch ISR router contain interface vlan configurations?()

  • A、performing inter - VLAN routing
  • B、performing 802.1Q trunking
  • C、performi ng ISL trunking
  • D、Ethernet Switch Module installed
  • E、ADSL WIC installed
  • F、running Call Manager Express

参考答案

更多 “Under which circumstance will a branch ISR router contain interface vlan configurations?()A、performing inter - VLAN routingB、performing 802.1Q trunkingC、performi ng ISL trunkingD、Ethernet Switch Module installedE、ADSL WIC installedF、running Call Manager Express” 相关考题
考题 将交换机的access端口ethernet0/1加入VLAN4,可用如下方法配置()。A.[Switch]vlan 4[Switch-vlan4]port ethernet0/1B.[Switch]vlan 4[Switch-Ethernet0/1]port access vlan 4C.[Switch]vlan 4[Switch-vlan4]port accesse thernet0/1D.[Switch]vlan 4[Switch-Ethernet0/1]port access vlan pvid 4[Huawei]vlan 3500[Huawei-Gigabit Ethernet0/0/1]disth interface Gigabit Ethernet0/0/1 port link-type access portdefault vlan 3500

考题 某网络的拓扑结构如图4-1所示,其中路由器Router1和交换机Switch1的部分配置如下:以下是路由器Router和Switch1的部分配置信息,请解释部分命令的意义。Router(config)interface fastEthernet1/0.1Router(config-subif)encapsulation isl 11 (1)Router(config-subif)ip address 10.1.1.1 255.255.255.0 (2)Router(config-subif)exitRouter(config)interface fastEthernet1/0.2Router(config-subif)encapsulation isl 12Router(config-subif)ip address 10.1.2.1 255.255.255.0Router(config-subif)exitRouter(config)interface fastEthernet1/0.3Router(config-subi f)encapsulation isl 13Router(config-subif)ip address 10.1.3.1 255.255.255.0Router(config-subif)exitRouter(config)ip routing (3)[交换机Switch1的部分配置信息]Switch1(config)vlan database (4)Switch1(vlan)vlan 11 (5)Switch1(vlan)vlan 12Switch1(vlan)vlan 13Switch1(vlan)exitSwitch1(config)interface fastEthernet0/0Switch1(config-if)switchport mode trunk (6)Switch1(config-if)switchport trunk allowed all (7)Switch1(config-if)exitSwitch1(config)interface fastEthernet0/1Switch1(config-if)switchport mode trunkSwitch1(config-if)switchport trunk a110wed a11Switch1(config-if)exitSwitch1(config)interface fastEthernet0/2Switch1(config-if)switchport mode trunkSwitch1(config-if)switchport trunk allowed allSwitch1(config-if)exit

考题 Under which circumstance will a branch ISR router contain interface vlan configurations?() A. performing inter - VLAN routingB. performing 802.1Q trunkingC. performi ng ISL trunkingD. Ethernet Switch Module installedE. ADSL WIC installedF. running Call Manager Express

考题 Under which network type circumstance would an OSPF router establish router adjacencies while not performing the DR/BDR election process?() A. Point-to-pointB. BroadcastC. Non-broadcast multi-accessD. Backbone area 0E. None of the above

考题 Refer to the exhibit. Given the output shown from this Cisco Catalyst 2950, what is the most likely reason that interface FastEthernet 0/10 is not the root port for VLAN 2?() A.This switch has more than one interface connected to the root network segment in VLAN 2.B.This switch is running RSTP while the elected designated switch is running 802.1d Spanning Tree.C.This switch interface has a higher path cost to the root bridge than another in the topology.D.This switch has a lower bridge ID for VLAN 2 than the elected designated switch.

考题 When configuring VLANs on an autonomous access point,what must be configured on theconnected switchport?()A、802.1q trunkingB、VTP trunkingC、ISL trunkingD、DPT trunking

考题 Vlans have been enabled on an autonomous access point. in order for clients associating to vlans other than the native vlan to receive an ip address. Which of the following must be configured?()A、access point ethernet port set to ssl trunkingB、switchport set to 802.1q trunkingC、switchport set to ssl trunkingD、access point ethernet port not set to 802.1q trunking

考题 In a switched environment, what does the IEEE 802.1Q standard describe?()A、the operation of VTPB、a method of VLAN trunkingC、an approach to wireless LAN communicationD、the process for root bridge selectionE、VLAN pruning vlan

考题 You are configuring a Cisco multilayer switch for the Company network.  Which command would  you use to configure a port to act as a routed interface?()A、 ip routingB、 switchport mode trunkC、 no switchportD、 switchport trunk native vlan 1E、 None of the other alternatives apply

考题 Under which network type circumstance would an OSPF router establish router adjacencies while not performing the DR/BDR election process?()A、Point-to-pointB、BroadcastC、Non-broadcast multi-accessD、Backbone area 0E、None of the above

考题 When configuring vlans on an autonomous access point. What must be configured on the connected switchport?()A、802.1q trunkingB、vtp trunkingC、isl trunkingD、dpt trunking

考题 A new Company switch was just configured using the "switchport trunk native vlan 7" command.   What does this interface command accomplish?()A、 Causes the interface to apply ISL framing for traffic on VLAN 7B、 Configures the trunking interface to forward traffic from VLAN 7C、 Configures the interface to be a trunking port and causes traffic on VLAN 7 to be 802.1q taggedD、 Configures the trunking interface to send traffic from VLAN 7 untaggedE、 None of the other alternatives apply

考题 Which statement ab0ut VLANs in a Cisco UCS is true?()A、Fabric interconnect can never participate in VTPB、Fabric interconnect supports ISL and 802.1Q trunkingC、The supported range of VLANs is auto-configured by UCSD、VLANs are configured through the Cisco UCS manager. (fabric interconnect may be set up in switch mode)

考题 A hacker on the Company network is attempting to hop onto a different VLAN.  Which two  statements about VLAN hopping are true? ()A、 An end station attempts to gain access to all VLANs by transmitting Ethernet frames in the  802.1q encapsulation.B、 Configuring an interface with the "switchport mode dynamic" command will prevent VLAN  hopping.C、 Attacks are prevented by utilizing the port-security feature.D、 Configuring an interface with the "switchport mode access" command will prevent VLAN  hopping.E、 An end station attempts to redirect VLAN traffic by broadcasting multiple ARP requests.

考题 A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router,as the routing protocol for the network.Which statement about thisnetwork is true?()A、For the two vlans to communicate,a network statement for the trunk interface needs to be added to the OSPF configuration.B、For the two vlans to communicate, a network statement for each subinterface needs to be  added  to the OSPF configuration.C、Direct inter-vlan communication does not require OSPFD、OSPF cannot be used if router-on-a-stick is configured on the router

考题 What is a characteristic of ISL and 802.1q frame tagging in a switched LAN environment?()A、They are used to find the best path through a network.B、They allow the exchange of filtering tables.C、They specify different implementations of the Spanning-Tree Protocol.D、They allow the exchange of routing tablesE、They provide inter-switch VLAN communication.

考题 The Company security administrator wants to prevent VLAN hopping on the network.  What is one  method that can be used to do this?  ()A、 Attacks are prevented by utilizing the port-security feature.B、 An end station attempts to gain access to all VLANs by transmitting Ethernet frames in the  802.1q encapsulation.C、 Configuring an interface with the switchport mode dynamic command will prevent VLAN  hopping.D、 An end station attempts to redirect VLAN traffic by transmitting Ethernet frames in the 802.1q  encapsulation.E、 Configuring an interface with the "switchport mode access" command will prevent VLAN  hopping.

考题 VLANs have been enabled on an autonomous access point. In order for clients associating toVLANs other than the native VLAN to receive an IP address which of the following must beconfigured?()A、access point Ethernet port set to SSL trunkingB、switchport set to 802.1q trunkingC、switchport set to SSL trunkingD、access point Ethernet port not set to 802.1q trunking

考题 The Company security administrator is concerned with VLAN hopping based attacks. Which two  statements about these attacks are true? ()A、 Attacks are prevented by utilizing the port-security feature.B、 An end station attempts to gain access to all VLANs by transmitting Ethernet frames in the  802.1q encapsulation.C、 Configuring an interface with the switchport mode dynamic command will prevent VLAN  hopping.D、 An end station attempts to redirect VLAN traffic by transmitting Ethernet frames in the 802.1q  encapsulation.E、 Configuring an interface with the "switchport mode access" command will prevent VLAN  hopping.

考题 Switch A is configured with VLAN 105 and 106. Switch Bis configured with VLAN 105 and 107.Both switches are connected with a fiber cable. In order for packets from all VLANs to cross thefiber cable, which of the following configurations MUST be present? ()A、Reverse ARPB、Full duplex on the fiber linkC、PoED、802.1q trunking

考题 A customer has two Ethernet Switch Modules installed in an IBM BladeCenter Enterprise chassis. The modules were configured identically. The Ethernet module in bay one was inadvertenly reset to factory defaults. Which solution returns the module to the customer-specific configuration?()A、Back up the configuration from Ethernet module in bay 2 and restore it to the module in Bay 1 using the switch CLI or Web interface B、Swap the modules, which will automatically resynch the settings stored in the Advanced Management Module C、Back up the configuration of the Ethernet module in bay one and restore it to the Ethernet module in bay two using the AMM D、Restore the configuration from NVRAM using the Switch Module Web interface

考题 Which two statements are correct regarding units in JUNOS?()A、Units in JUNOS are always required for any interface configured with logical addresses such as IP and IPv6.B、Units in JUNOS are only required when you are configuring sub-interfaces for inter-VLAN routing.C、Unit numbers must match the DLCI or VCI numbers configured on the interface.D、Unit 0 is the only value allowed on interfaces running HDLC, PPP, or for Ethernet interfaces not doing VLAN-tagging.

考题 单选题Under which circumstance will a branch ISR router contain interface vlan configurations?()A performing inter - VLAN routingB performing 802.1Q trunkingC performi ng ISL trunkingD Ethernet Switch Module installedE ADSL WIC installedF running Call Manager Express

考题 多选题The Company security administrator is concerned with VLAN hopping based attacks. Which two  statements about these attacks are true? ()AAttacks are prevented by utilizing the port-security feature.BAn end station attempts to gain access to all VLANs by transmitting Ethernet frames in the  802.1q encapsulation.CConfiguring an interface with the switchport mode dynamic command will prevent VLAN  hopping.DAn end station attempts to redirect VLAN traffic by transmitting Ethernet frames in the 802.1q  encapsulation.EConfiguring an interface with the switchport mode access command will prevent VLAN  hopping.

考题 单选题A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router,as the routing protocol for the network.Which statement about thisnetwork is true?()A For the two vlans to communicate,a network statement for the trunk interface needs to be added to the OSPF configuration.B For the two vlans to communicate, a network statement for each subinterface needs to be  added  to the OSPF configuration.C Direct inter-vlan communication does not require OSPFD OSPF cannot be used if router-on-a-stick is configured on the router

考题 单选题Under which network type circumstance would an OSPF router establish router adjacencies while not performing the DR/BDR election process?()A Point-to-pointB BroadcastC Non-broadcast multi-accessD Backbone area 0E None of the above

考题 单选题A new Company switch was just configured using the "switchport trunk native vlan 7" command.   What does this interface command accomplish?()A  Causes the interface to apply ISL framing for traffic on VLAN 7B  Configures the trunking interface to forward traffic from VLAN 7C  Configures the interface to be a trunking port and causes traffic on VLAN 7 to be 802.1q taggedD  Configures the trunking interface to send traffic from VLAN 7 untaggedE  None of the other alternatives apply