网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
An administrator reboots a ten drive server, with a RAID 10 array, after a power failure and receives an error logical drive failed. Which of the following is the MOST likely cause?（）
- A、Corrupt file system table
- B、Backplane failure
- C、Multiple drive failure
- D、Bad cable
参考答案
更多 “An administrator reboots a ten drive server, with a RAID 10 array, after a power failure and receives an error logical drive failed. Which of the following is the MOST likely cause?（）A、Corrupt file system tableB、Backplane failureC、Multiple drive failureD、Bad cable” 相关考题
考题
There is a power outage and all servers are shut down properly by the uninterruptible power supply (UPS) software. When one of the servers starts up it displays a logical drive failed error. This server has two processors, 16GB of memory, and a RAID 5 array with 10 drives.Which of the following is the MOST likely cause?（）A. A failed RAID controllerB. Two failed processorsC. Two failed sticks of memoryD. Two failed drives
考题
An administrator has shut down a server to install additional memory. When the administrator restarts the server after the upgrade, it times out. Which of the following could be the cause of the problem?（）A. Processor failureB. Third party memoryC. Disk drive failureD. ESD during the upgradeE. Backplane failure
考题
After installing a new hard drive into a server for the purpose of mirroring the data from the first drive to the second one， the server displays an “operating system not found” error. Which of the following should the technician do to boot the server from the original drive？（）A、Replace the second drive with a hot swappable one.B、Swap the drive boot order in the BIOSC、Make the second disk active under the disk management tool.D、Rebuild the array using the hardware RAID tool at boot.
考题
After performing the initial steps in installing the server OS from a DVD-ROM， the server reboots and goes back into the setup wizard. Which of the following is the MOST likely cause for this problem？（）A、The DVD-ROM drive has failed.B、An installation file copied from the DVD to the hard drive is corrupt.C、Faulty OS installation DVDD、Incorrect boot sequence in the BIOS
考题
A user reports that after configuring the BIOS to boot to the hard drive first, the system still tries to boot from the optical drive. Which of the following is the MOST likely cause?（）A、Optical driveB、Power supplyC、CMOS batteryD、CD-ROM disk
考题
A server has a single failed hard drive in an array that is accessed through a hot plug backplane to ease replacement of failed drives. After replacing the drive several times， each of the replacement drives failed to power up and rebuild as the failed drive. Which of the following is the MOST likely cause of the failures？（）A、 The backplane has failed and needs to be replaced.B、 The array must be disbanded and recreated from a backup source to recognize the replacement drive.C、 There is a conflict with the optical drive on the server.D、 The server power supply is failing and not providing enough power for all the drives.
考题
After a server inspection， an administrator notices a single drive failure on a server configured with RAID 5. Which of the following is the NEXT step to start rebuilding the array？（）A、Reestablish the mirror array.B、Perform online volume expansion.C、Insert hot plug drive.D、Move data to another volume.
考题
A Windows 2003 server has the operating system installed on a software RAID mirror. After a failure of one disk in the array the server will no longer boot up. The other drive is still functioning. Which of the following should be done to correct the issue？ （）A、 Edit the boot.ini file.B、 Change to a hardware RAID solution.C、 Recreate the array.D、 Edit the active drive in the array.
考题
A technician is unable to eject a tape from a drive when pressing the eject button. Which of the following is MOST likely the cause？（）A、Corrupt OSB、Array is rebuildingC、Driver problemD、Drive failure
考题
A server has had a drive fail in its storage RAID set. The administrator swaps the drive with a replacement and the RAID set does not automatically start to rebuild the replaced drive. Which ofthe following utilities would MOST likely be used to initialize the rebuilding of the replace mentdrive？（）A、Net useB、Array managementC、FdiskD、Disk Management Plug-in
考题
Which of the following could cause an Inaccessible boot drive error during the boot process? （）A、HDD failureB、DVI failureC、USB failureD、CD failure
考题
A computer has been upgraded with a new hard drive and after reassembling the computer and turning the computer on， the drive LED remains lit and an error message during power-on self test （POST） states， ’No Drive Present.’ Which of the following would MOST likely be the cause？（）A、The motherboard was damaged and needs replacing.B、The floppy drive was not reconnected.C、A configuration disk was left in the floppy drive.D、The ribbon cable has been installed incorrectly.
考题
A disk drive failed in a RAID 5 array. After replacing the disk drive， users are still reporting that access to the server is very slow. Which of the following BEST explains the problem？（）A、The array is rebuilding.B、The array must be reconfigured.C、The array is corrupt.D、The disk drive is not compatible.
考题
An administrator adds a new SATA hard drive into a functional server and attempts to boot the server. The server will no longer boot into the operating system. The administrator checks all the connections and reboots the server. The server still will not load the operating system. Which of the following is the MOST probable cause？（）A、The BIOS is set with the wrong boot order.B、The jumpers have not been set on the hard drive.C、The hard drive is not compatible with the system board.D、The boot.ini file needs to be modified.
考题
There is a power outage and all servers are shut down properly by the uninterruptible power supply（UPS） software. When one of the servers starts up it displays a logical drive failed error. This server has two processors，16GB of memory， and a RAID 5 array with 10 drives. Which of the following is the MOST likely cause？（）A、 A failed RAID controllerB、 Two failed processorsC、 Two failed sticks of memoryD、 Two failed drives
考题
A file server is setup in a RAID 5 configuration.Recently there was a power failure in the server room while a user was transferring a document from one drive on the server to another drive on the same server.Unfortunately their UPS was in repair during this outage， and the file is now corrupt.Which of the following can be done to prevent this situation in the future？（）A、Increase the memory on the server.B、Reconfigure drives to a RAID 0+1.C、Install a battery backed write cache module in the system.D、Instruct the user to save to the local system instead of to the server.
考题
An administrator has shut down a server to install additional memory. When the administrator restarts the server after the upgrade, it times out. Which of the following could be the cause of the problem?（）A、Processor failureB、Third party memoryC、Disk drive failureD、ESD during the upgradeE、Backplane failure
考题
单选题After performing the initial steps in installing the server OS from a DVD-ROM， the server reboots and goes back into the setup wizard. Which of the following is the MOST likely cause for this problem？（）A
The DVD-ROM drive has failed.B
An installation file copied from the DVD to the hard drive is corrupt.C
Faulty OS installation DVDD
Incorrect boot sequence in the BIOS
考题
单选题A computer has been upgraded with a new hard drive and after reassembling the computer and turning the computer on， the drive LED remains lit and an error message during power-on self test （POST） states， ’No Drive Present.’ Which of the following would MOST likely be the cause？（）A
The motherboard was damaged and needs replacing.B
The floppy drive was not reconnected.C
A configuration disk was left in the floppy drive.D
The ribbon cable has been installed incorrectly.
考题
单选题A user reports that after configuring the BIOS to boot to the hard drive first, the system still tries to boot from the optical drive. Which of the following is the MOST likely cause?（）A
Optical driveB
Power supplyC
CMOS batteryD
CD-ROM disk
考题
单选题A server has a single failed hard drive in an array that is accessed through a hot plug backplane to ease replacement of failed drives. After replacing the drive several times， each of the replacement drives failed to power up and rebuild as the failed drive. Which of the following is the MOST likely cause of the failures？（）A
The backplane has failed and needs to be replaced.B
The array must be disbanded and recreated from a backup source to recognize the replacement drive.C
There is a conflict with the optical drive on the server.D
The server power supply is failing and not providing enough power for all the drives.
考题
单选题An administrator adds a new SATA hard drive into a functional server and attempts to boot the server. The server will no longer boot into the operating system. The administrator checks all the connections and reboots the server. The server still will not load the operating system. Which of the following is the MOST probable cause？（）A
The BIOS is set with the wrong boot order.B
The jumpers have not been set on the hard drive.C
The hard drive is not compatible with the system board.D
The boot.ini file needs to be modified.
考题
单选题A Windows 2003 server has the operating system installed on a software RAID mirror. After a failure of one disk in the array the server will no longer boot up. The other drive is still functioning. Which of the following should be done to correct the issue？ （）A
Edit the boot.ini file.B
Change to a hardware RAID solution.C
Recreate the array.D
Edit the active drive in the array.
考题
单选题A server has had a drive fail in its storage RAID set. The administrator swaps the drive with a replacement and the RAID set does not automatically start to rebuild the replaced drive. Which ofthe following utilities would MOST likely be used to initialize the rebuilding of the replace mentdrive？（）A
Net useB
Array managementC
FdiskD
Disk Management Plug-in
考题
单选题A disk drive failed in a RAID 5 array. After replacing the disk drive， users are still reporting that access to the server is very slow. Which of the following BEST explains the problem？（）A
The array is rebuilding.B
The array must be reconfigured.C
The array is corrupt.D
The disk drive is not compatible.
考题
单选题An administrator reboots a ten drive server, with a RAID 10 array, after a power failure and receives an error logical drive failed. Which of the following is the MOST likely cause?（）A
Corrupt file system tableB
Backplane failureC
Multiple drive failureD
Bad cable
考题
单选题An administrator reboots a ten drive server， with a RAID 10 array， after a power failure and receives an error logical drive failed. Which of the following is the MOST likely cause？（）A
Corrupt file system tableB
Backplane failureC
Multiple drive failureD
Bad cable
热门标签
最新试卷
