网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?（）
- A、IETF
- B、HDLC
- C、Q9333-A Annex A
- D、ANSI Annex D
参考答案
更多 “Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?（）A、IETFB、HDLCC、Q9333-A Annex AD、ANSI Annex D” 相关考题
考题
Which code causes only a Level 2 adjacency to be formed under the SONET interface so-2/2/2 withFrame Relay encapsulation?Which code causes only a Level 2 adjacency to be formed under the SONET interface so-2/2/2 with Frame Relay encapsulation?（）A.B.C.D.
考题
You are bringing up a new Ezonexam switch, and wish to connect it via a trunk to another switch from a different vendor, which uses the IEEE standard for the trunking method. When setting the encapsulation type on the trunk, what should you configure on the Cisco switch?A．Switch(config)# switchport trunk encapsulation islB．Switch(config)# switchport trunk encapsulation ietfC．Switch(config-if)# switchport trunk encapsulation islD．Switch(config-if)# switchport trunk encapsulation ietfE．Switch(config-if)# switchport trunk encapsulation dot1q
考题
You are preparing to create a point to point WAN by connecting a Cisco router with a Juniper router by way of their serial links. Which one of the following commands would you use?()
A. TK1(config-if)# encapsulation hdlc ansiB. TK1(config-if)# encapsulation pppC. TK1(config-if)# encapsulation LAPDD. TK1(config-if)# encapsulation frame-relay ietfE. TK1(config)#encapsulation ppp
考题
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?()
A. IETFB. HDLCC. Q9333-A Annex AD. ANSI Annex D
考题
Which layer 2 protocol encapsulation type supports synchronous and asynchronous circuis and has built－in security mechanisms?()
A. Frame RelayB. HDLCC. x.25D. PPP
考题
Refer to the exhibit.What is the reason that the interface status is “administratively down,line protocol down”?()
A.There is a mismatch in encapsulation typesB.The wrong type of cable is connected to the interfaceC.The interface has been configured with the shutdown commandD.The interface is not receiving any keepalivesE.The interface needs to be configured as a DTE deviceF.There is no encapsulation type configured
考题
which command allows you to verify the encapsulation type (CISCO OR IETF) for a frame relay link?()
A.show frame-relay mapB.show frame-relay lmiC.show inter serialD.show frame-relay pvc
考题
When configuring Frame Relay using point-to-point subinterfaces, which of the following must not be configured?（）A、The local DLCI on each subinterface of the Frame Relay.B、The Frame Relay encapsulation on the physical interface.C、An IP address on the physical interface.D、The subinterface type as point-to-point
考题
which one of the following statements would lee include in an agent to limit the documents processed by the agent to those for which the value of the type field is "action"? （）A、FIELD Type :="action" B、SELECT Type ="action" C、SELECT Type :="action " D、@if (type="action";@success;@failure)
考题
想要设置帧中继LMI类型为ANSI，应该（）A、在系统模式下使用命令fr lmi type ANSIB、在接口模式下使用命令fr lmi type ANSIC、在系统模式下使用命令fr lmi class ANSID、在接口模式下使用命令fr lmi class ANSI
考题
You work as a network technician at Company. Your boss， Ms.， is interested LWAPP （Lightweight Access Point Protocol）. In particular she wants to know which type of activities this protocol defines. What should you tell her？ （）A、 Layer 3 addressing and distributionB、 SNMP monitoring servicesC、 Access point certification and software controlD、 Packet encapsulation， fragmentation， and formattingE、 Compression and Layer 3 address mappingF、 User behaviors
考题
You are preparing to create a point to point WAN by connecting a Cisco router with a Juniper router by way of their serial links. Which one of the following commands would you use?（）A、TK1(config-if)# encapsulation hdlc ansiB、TK1(config-if)# encapsulation pppC、TK1(config-if)# encapsulation LAPDD、TK1(config-if)# encapsulation frame-relay ietfE、TK1(config)#encapsulation ppp
考题
Refer to the exhibit.What is the reason that the interface status is “administratively down,line protocol down”?（）A、There is a mismatch in encapsulation typesB、The wrong type of cable is connected to the interfaceC、The interface has been configured with the shutdown commandD、The interface is not receiving any keepalivesE、The interface needs to be configured as a DTE deviceF、There is no encapsulation type configured
考题
You are bringing up a new Cisco Catalyst switch, and wish to connect it via a trunk to another switch from a different vendor, which uses the IEEE standard for the trunking method. When setting the encapsulation type on the trunk, what should you configure on the Cisco switch?（）A、Switch(config)# switchport trunk encapsulation islB、Switch(config)# switchport trunk encapsulation ietfC、Switch(config-if)# switchport trunk encapsulation islD、Switch(config-if)# switchport trunk encapsulation ietfE、Switch(config-if)# switchport trunk encapsulation dot1q
考题
You need to configure a new Company switch for trunking. Which switch command enables a trunking protocol that appends a four byte CRC to the packet？（）A、 CompanySwitch（config-if）#switchport trunk encapsulation dot1qB、 CompanySwitch（config-if）#switchport trunk encapsulation itefC、 CompanySwitch（config-if）#switchport trunk encapsulation fddiD、 CompanySwitch（config-if）#switchport trunk encapsulation islE、 None of the other alternatives apply
考题
Which layer 2 protocol encapsulation type supports synchronous and asynchronous circuis and has built-in security mechanisms?（）A、Frame RelayB、HDLCC、x.25D、PPP
考题
which command allows you to verify the encapsulation type CISCO OR IETF for a frame relay link?（）A、show frame-relay mapB、show frame-relay lmiC、show inter serialD、show frame-relay pvc
考题
Which of the following is an unlikely reason for the ARP process to fail？（）A、CEF switching is disabled on the switchB、The source device and destination device are in different VLANsC、The VLAN is excluded from the trunkD、The host is connected to the switch through an IP phoneE、A faulty cable from host to switch or between switchesF、The trunking encapsulation type is inconsistent on the two ends of the link
考题
多选题Which of the following is an unlikely reason for the ARP process to fail？（）ACEF switching is disabled on the switchBThe source device and destination device are in different VLANsCThe VLAN is excluded from the trunkDThe host is connected to the switch through an IP phoneEA faulty cable from host to switch or between switchesFThe trunking encapsulation type is inconsistent on the two ends of the link
考题
单选题In JUNOS software, which type of encapsulation is required on a PE router for the CE-facinginterface in a Martini-based VPN?（）A
ATMB
CCCC
HDLCD
Ethernet
考题
单选题Refer to the exhibit.What is the reason that the interface status is “administratively down,line protocol down”?（）A
There is a mismatch in encapsulation typesB
The wrong type of cable is connected to the interfaceC
The interface has been configured with the shutdown commandD
The interface is not receiving any keepalivesE
The interface needs to be configured as a DTE deviceF
There is no encapsulation type configured
考题
单选题When configuring Frame Relay using point-to-point subinterfaces, which of the following must not be configured?（）A
The local DLCI on each subinterface of the Frame Relay.B
The Frame Relay encapsulation on the physical interface.C
An IP address on the physical interface.D
The subinterface type as point-to-point
考题
单选题In JUNOS software， which type of encapsulation is required on a PE router for the CE-facing interface in a Martini-based VPN？（）A
ATMB
CCCC
HDLCD
Ethernet
考题
单选题You are preparing to create a point to point WAN by connecting a Cisco router with a Juniper router by way of their serial links. Which one of the following commands would you use?（）A
TK1(config-if)# encapsulation hdlc ansiB
TK1(config-if)# encapsulation pppC
TK1(config-if)# encapsulation LAPDD
TK1(config-if)# encapsulation frame-relay ietfE
TK1(config)#encapsulation ppp
考题
单选题which one of the following statements would lee include in an agent to limit the documents processed by the agent to those for which the value of the type field is "action"? （）A
FIELD Type :=action B
SELECT Type =action C
SELECT Type :=action D
@if (type=action;@success;@failure)
考题
单选题Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?（）A
IETFB
HDLCC
Q9333-A Annex AD
ANSI Annex D
考题
多选题You work as a network technician at Company. Your boss， Ms.， is interested LWAPP （Lightweight Access Point Protocol）. In particular she wants to know which type of activities this protocol defines. What should you tell her？ （）ALayer 3 addressing and distributionBSNMP monitoring servicesCAccess point certification and software controlDPacket encapsulation， fragmentation， and formattingECompression and Layer 3 address mappingFUser behaviors
热门标签
最新试卷
