网友您好, 请在下方输入框内输入要搜索的题目:
题目内容
(请给出正确答案)
单选题
After testing a new 100BaseTX cable, the technician determines that only pairs 4, 5, 7, and 8 are straight-thru wires. Which of the following MOST likely describes this cable type?()
A
Crossover cable with open pairs
B
Crossover cable
C
Rollover cable
D
Straight-thru cable with open pairs
参考答案
参考解析
解析:
暂无解析
更多 “单选题After testing a new 100BaseTX cable, the technician determines that only pairs 4, 5, 7, and 8 are straight-thru wires. Which of the following MOST likely describes this cable type?()A Crossover cable with open pairsB Crossover cableC Rollover cableD Straight-thru cable with open pairs” 相关考题
考题
After making a long CAT5 cable, the technician fears that the cable may have been damagedduring the pull, but does not have a cable tester. Which of the following would be the BESTalternative tool to determine whether there are any breaks or shorts in the cable?()A. MultimeterB. VoltmeterC. Loopback plugD. Toner probe
考题
A user is trying to connect their new desktop to the network but is unable to get an IP address.The technician tests the cable and finds that there are too many open pairs.Which of the following wiring standards needs to be used in the replacement cable?()A. 568BB.CrossoverC. 569-AD. 607-A
考题
An administrator is having a hard time adding a new switch to the network. After verifying that allthe ports are configured correctly on each switch, which of the following should the administratorverily NEXT?()A. Straight-through cable is used to connect both switchesB. Loopback plug is connectedC. Crossover cable is used to connect both switchesD. Cable is a rollover cable
考题
A user is trying to connect their new desktop to the network but is unable to get an IP address. The technician tests the cable and finds that there are too many open pairs. Which of the following wiring standards needs to be used in the replacement cable?()A、568BB、CrossoverC、569-AD、607-A
考题
Which of the following tools should Mike, a technician, use when testing a serial port?()A、Cable testerB、MultimeterC、Loopback plugD、Logic probe
考题
The network technician is troubleshooting a network issue by implementing a new security device.After installing and configuring the device, which of the following steps should the technician takeNEXT?()A、Verity full system functionalityB、Identify the main problem and question the userC、Document their findings, actions, and outcomesD、Escalate the issue to upper management
考题
A technician purchases a new 120 GB IDE hard disk to use in an old server as a swap drive. After adding the drive to the server, the technician discovers that the operating system does not detect the drive. After rebooting the server, the technician notices the drive is missing from POST and comes to the conclusion that the BIOS needs to be updated. The technician downloads the latest version of the BIOS update from the manufacturer website. Which action should the technician take next?()A、 backup the BIOS configuration to use laterB、 install the BIOS update from a command promptC、 create a bootable floppy and copy the BIOS update tools to the floppyD、 read the manufacturer’s guidelines and recommendations on installing the update
考题
After a technician came out and installed a new wireless router, one of the wired workstations began having problems connecting to the file server. This is only an intermittent problem. Which of the following actions will the technician MOST likely perform to resolve this problem?()A、Change the router's SSIDB、Move the router's locationC、Check user permissionsD、Check the cable ends
考题
After a technician installs a new CMOS battery on a motherboard, which of the following will thetechnician have to change? ()A、Firmware versionB、System date/timeC、Bus speedsD、Jumper settings
考题
A technician replaced a floppy drive and now the front indicator light is consistently illuminated.Which of the following is the cause for this?()A、It is a feature of new floppy drives.B、The data cable was put on backwards.C、A disk is being read by the floppy drive.D、The new floppy drive is defective.
考题
After setting up a new computer, a user states that the mouse and keyboard will not work. Whichof the following is the MOST likely reason?()A、The network cable is disconnectedB、The PS/2 connectors are switchedC、The USB connectors are switchedD、The hard drive is unplugged
考题
A technician installed a new application on a Windows XP desktop. After the application wasinstalled, the technician rebooted the desktop and received a bluescreen error. Which of thefollowing steps should the technician perform?() (Select TWO).A、Boot into Safe ModeB、Replace the motherboardC、Uninstall the applicationD、Replace the hard driveE、Install more RAM
考题
An administrator is having a hard time adding a new switch to the network. After verifying that allthe ports are configured correctly on each switch, which of the following should the administratorverily NEXT?()A、Straight-through cable is used to connect both switchesB、Loopback plug is connectedC、Crossover cable is used to connect both switchesD、Cable is a rollover cable
考题
A technician needs to find an end of a network cable drop. Which of the following tools would the technician use?()A、Cable testerB、MultimeterC、Toner probeD、Loopback plug
考题
Bob, a technician, is adding a secondary IDE hard drive to an older system. After installation and the first boot, the drive is not showing in Disk Management. Which of the following is the MOST likely cause of the issue?()A、The new drive’s jumper is set for master.B、The new drive is connected to the secondary bus as a slave drive.C、Both drives’ jumpers are set for cable select.D、The old drive’s jumper is set for master and the new drive is set for slave.
考题
After testing a new 100BaseTX cable, the technician determines that only pairs 4, 5, 7, and 8 are straight-thru wires. Which of the following MOST likely describes this cable type?()A、Crossover cable with open pairsB、Crossover cableC、Rollover cableD、Straight-thru cable with open pairs
考题
When testing a CAT5 cable, the technician notices that pin A is open. However, the cable stillworks fine. Which of the following describes how this is possible?()A、The cable was tested for 100Base-TX.B、The cable is a 1000BaseT cable.C、The switch uses link aggregation,D、The switch was setup to use MDIX
考题
A user has just moved a PC from one office to another. The patch cable and the NIC do notappear to be functioning in the new office but were working before the move. The patch cable is plugged in correctly to both the NIC and the wall jack. Which of the following actions should the technician take FIRST?()A、Verify that the network card is compatible with the operating system.B、Verify that the port on the switch is enabled.C、Update the network card driver.D、Replace the network cable with a crossover cable.
考题
A technician needs to install additional access points for a new high speed connection being added in the new office space. Which of the following will MOST likely be installed to allow additional CAT5 cable connections?()A、Smart JackB、DemarcC、110 BlockD、66 Block
考题
多选题A technician installed a new application on a Windows XP desktop. After the application wasinstalled, the technician rebooted the desktop and received a bluescreen error. Which of thefollowing steps should the technician perform?() (Select TWO).ABoot into Safe ModeBReplace the motherboardCUninstall the applicationDReplace the hard driveEInstall more RAM
考题
单选题Bob, a technician, is adding a secondary IDE hard drive to an older system. After installation and the first boot, the drive is not showing in Disk Management. Which of the following is the MOST likely cause of the issue?()A
The new drive’s jumper is set for master.B
The new drive is connected to the secondary bus as a slave drive.C
Both drives’ jumpers are set for cable select.D
The old drive’s jumper is set for master and the new drive is set for slave.
考题
单选题A technician needs to install additional access points for a new high speed connection being added in the new office space. Which of the following will MOST likely be installed to allow additional CAT5 cable connections?()A
Smart JackB
DemarcC
110 BlockD
66 Block
考题
单选题When testing a CAT5 cable, the technician notices that pin A is open. However, the cable stillworks fine. Which of the following describes how this is possible?()A
The cable was tested for 100Base-TX.B
The cable is a 1000BaseT cable.C
The switch uses link aggregation,D
The switch was setup to use MDIX
考题
单选题A technician has installed a new motherboard in a workstation, but after hardware tests, themotherboard has failed. Which of the following should the technician do FIRST before replacingthe motherboard? ()A
Reseat all power connections.B
Remove the CMOS battery.C
Install the graphics card.D
Ground to the case.
考题
单选题A technician purchases a new 120 GB IDE hard disk to use in an old server as a swap drive. After adding the drive to the server, the technician discovers that the operating system does not detect the drive. After rebooting the server, the technician notices the drive is missing from POST and comes to the conclusion that the BIOS needs to be updated. The technician downloads the latest version of the BIOS update from the manufacturer website. Which action should the technician take next?()A
backup the BIOS configuration to use laterB
install the BIOS update from a command promptC
create a bootable floppy and copy the BIOS update tools to the floppyD
read the manufacturer’s guidelines and recommendations on installing the update
考题
单选题A technician replaced a floppy drive and now the front indicator light is consistently illuminated.Which of the following is the cause for this?()A
It is a feature of new floppy drives.B
The data cable was put on backwards.C
A disk is being read by the floppy drive.D
The new floppy drive is defective.
考题
单选题After making a long CAT5 cable, the technician fears that the cable may have been damagedduring the pull, but does not have a cable tester. Which of the following would be the BESTalternative tool to determine whether there are any breaks or shorts in the cable?()A
MultimeterB
VoltmeterC
Loopback plugD
Toner probe
考题
单选题An administrator is having a hard time adding a new switch to the network. After verifying that allthe ports are configured correctly on each switch, which of the following should the administratorverily NEXT?()A
Straight-through cable is used to connect both switchesB
Loopback plug is connectedC
Crossover cable is used to connect both switchesD
Cable is a rollover cable
热门标签
最新试卷