网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
单选题
Fuel is not supplied to the corresponding cylinders due to （）.
A
a failure of the motor
B
a failure of lubricator
C
a failure of cylinder
D
a failure of fuel pump
参考答案
参考解析
解析：
暂无解析
更多 “单选题Fuel is not supplied to the corresponding cylinders due to （）.A a failure of the motorB a failure of lubricatorC a failure of cylinderD a failure of fuel pump” 相关考题
考题
If you suspect a diesel engine is misfiring due to air leakage into the fuel system, you should begin looking for the leak at theA.fuel line connections to the cylinder injection valvesB.gasket surfaces of the fuel oil filtersC.discharge fittings of the fuel injector pumpsD.suction side of the fuel oil transfer pump
考题
If the engine does not start on air, it may be due toA.low compression of the fuel pumpsB.incorrect timing of fuel pumpsC.the starting air valves stuckD.air-locks in fuel oil pipeline
考题
Fuel has been injected but ignition fails. The possible cause may be ______.A.slightly leaky exhaust valveB.increased scavenging air temperatureC.engine cylinders not scavenged sufficientlyD.too much water in the fuel oil
考题
单选题When a ship is entering to shallow water, ship resistance will be increased and the speed of main engine reduced.Due to the function of the governor, the main engine will（）A
reduce fuel feedingB
increase fuel feedingC
keep original fuel feedingD
be overspeed
考题
单选题The ignition of the fuel in diesel engine is caused by the （） of compression of the air previously admitted into the cylinders.A
vacuum pressureB
specific gravityC
heatD
viscosity
考题
单选题Fuel is not supplied to the corresponding cylinder due to a failure of （）.A
the motorB
the fresh water generatorC
the governorD
the fuel pump
考题
单选题Combustion knock can occur in the cylinders of a diesel engine under any condition permitting （）.A
a shortened ignition delay periodB
a lean fuel/air mixtureC
excess fuel in the combustion chamberD
rapid vaporization of injected fuel droplets
考题
单选题Successful combustion inside the cylinders of a diesel engine is dependent upon （）.A
fine atomizationB
high temperatureC
good mixing of fuel and airD
all of the above
考题
单选题If a tow-stroke/diesel engine is over-speeding due to leakage of lube oil into the cylinders, what should you do to stop the engine?（）A
Move the fuel control mechanism to the no fuel positionB
Block the fuel supply by closing the master fuel valveC
Shut off the fuel supply and block the flow of intake airD
Relieve all pressure in the fuel system
考题
单选题The air supplied to the cylinders by a turbocharger is often reduced in volume by a/an （）A
air compressorB
diffuserC
after-coolerD
ventilator
考题
单选题Turbulence is created in the cylinders of a diesel engine to （）A
obtain injection lagB
help mix fuel and airC
increase combustion pressureD
utilize higher injection pressures
考题
单选题The engine will fail to start unless （）.A
the pressure of the starting air is high enoughB
there is enough air in the air reservoirsC
the air is supplied into the cylinders in the appropriate sequenceD
all of the above
考题
单选题The sequence of fuel injection into cylinders is determined by （）.A
the steeringB
the driven gearC
the turning gearD
the timing gear
考题
单选题Which of the following is true of the heating system of the Johnstown campus?A
The heat is supplied by human bodies only.B
The heat is supplied by both human bodies and other heat-emitting objects.C
The heat is supplied by both human bodies and conventional fuel.D
The heat is supplied by human bodies, other heat-emitting objects, and conventional fuel.
考题
单选题Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the（）A
double bottom fuel oil tank temperatureB
heater supply steam flowC
pressure of the fuel supplied to the burnersD
attemperator steam flow in the heater discharge circuit
考题
单选题If the engine does not start on air, it may be due to （）A
low compression of the fuel pumpsB
incorrect timing of fuel pumpsC
the starting air valves stuckD
air-locks in fuel oil pipeline
考题
单选题The fuel is supplied to the pump through ports or openings in the （） or cylinder of the pump.A
bottleB
injectorC
pistonD
barrel
考题
单选题Low compression pressure in a diesel engine may be the result of （）A
insufficient fuel supply due to fuel pump valves sticking or leakingB
excessive mechanical clearance between the piston crown and cylinder headC
excessively worn fuel pump plungerD
excessive exhaust back pressure
考题
单选题Surface irregularities, such as erosion and pitting on injection pump plungers, will（）A
increase ignition delayB
affect fuel oil meteringC
affect engine performance at low speedD
only disappear due to fuel oil abrasion
考题
单选题Once all cylinders are firing regularly, （） is shut off.A
the exhaust valveB
the starting airC
the inlet valveD
the fuel oil
考题
单选题If you suspect a diesel engine is misfiring due to air leakage into the fuel system, you should begin looking for the leak at the （）A
fuel line connections to cylinder injection valvesB
gasket surfaces of the fuel oil filtersC
discharge fitting of the fuel injector pumpsD
suction side of the fuel oil tran
考题
单选题Fuel injectors used in heavy fuel oil systems are usually provided with cooling to reduce（）.A
cold corrosion of the nozzlesB
fuel viscosity for better atomizationC
carbon accumulation on the nozzlesD
fuel detonation in the cylinders
考题
单选题When the load is increased on a turbocharged diesel engine, the amount of increased air supplied by the turbocharger will（）A
lag behind the increased fuel supplied to the engineB
enter the engine along with the increase in the fuelC
enter the engine before the increased fuel supplyD
leave the turbocharger as a negative pulse
考题
单选题Fuel has been injected but ignition fails The possible cause may be （）.A
leaky exhaust valveB
increased scavenging air temperatureC
engine cylinders not scavenged sufficientlyD
water in the fuel oil
考题
单选题In common rail engines, the fuel is（） before is injected into the cylinders.A
stored in a common fuel lineB
pumped by the injection pumpC
at low pressureD
already atomized
考题
单选题Some diesel engines are fitted with a thermometer in the cooling water outlet from each cylinderIf the cooling water temperature from all cylinders begins to rise above normal, you should suspect （）A
increase blow-by in all cylindersB
incomplete combustion in all cylinderC
overloading in all cylindersD
insufficient fuel delivery to all cylinders
考题
单选题（） rods are not in proper condition so that too much fuel is supplied to the corresponding cylinder.A
PistonB
SoundingC
RegulatingD
Connecting
热门标签
最新试卷
