思科认证 2021_04_07 每日一练
During startup, router VE1 displays the following error message:
boot: cannot open "flash:"
What will VE1 do next?
A. It will attempt to locate the configuration file from a TFTP server. If this fails, it will initiate the setup dialog.
B. It will attempt to locate the IOS from a TFTP server. If this fails, it will load a limited IOS from ROM.
C. It will attempt to locate the configuration file from a TFTP server. If this fails, it will load a limited configuration from ROM.
D. Because of damaged flash memory, the router will fail the POST.
E. It will attempt to locate the IOS from a TFTP server. If this fails, it will initiate the setup dialog.
F. None of the above
When is a switched network that is running the Spanning Tree Protocol considered to be fully converged?
A.when all switches have the same BID as the root switch
B.when all switches have received the MAC address of each neighboring switch
C.when every enabled switch port has been assigned a unique identifier
D.when every operating switch port is in either the blocking or forwarding state
E.when all switches are in either client, server, or transparent mode
A Ezonexam Ethernet switch receives a unicast frame. with a destination MAC that is listed in the switch table. What will this switch do with the frame?
A. The switch will forward the frame. to a specific port
B. The switch will forward the frame. to all ports except the port on which it was received
C. The switch will return a copy of the frame. out the source port
D. The switch will not forward unicast frames
E. The switch will remove the destination MAC from the switch table
F. None of the above.