网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
What is the most likely reason for the dispartly between the actual network numbers at the branches and the routes in the routing table on Gateway－Router?()
A. Branch-Router2 is configured to send both RIPv1 and RIPv2 updates.
B. Gateway-Router is configured to only receive RIPv2 updates.
C. Gateway-router is configured to receive only RIPv1 updates.
D. Branch-Router1 is configured to only send RIPv1 updates
参考答案
更多 “ What is the most likely reason for the dispartly between the actual network numbers at the branches and the routes in the routing table on Gateway－Router?() A. Branch-Router2 is configured to send both RIPv1 and RIPv2 updates.B. Gateway-Router is configured to only receive RIPv2 updates.C. Gateway-router is configured to receive only RIPv1 updates.D. Branch-Router1 is configured to only send RIPv1 updates ” 相关考题
考题
In what location are EIGRP successor routes stored?()
A. In the routing table only.B. In the neighbor table only.C. In the topology table only.D. In the routing table and neighbor table.E. In the routing table and topology table.F. In the topology table and neighbor table.
考题
What are some of the characteristics of the OSPF routing protocol?()
A. It confines network instability to a single area of network.B. It increases the routing overhead of the networkC. It supports VLSMD. It routes between Autonomous Systems.E. It allows extensive control of routing updatesF. None of the above
考题
Refer to the exhibit. Which two statement s are correct?()
A. All the routes were redistributed into BGP from an IGPB. All the routes were originated by BGP with the network commandC. All six routes will be installed in the routing tableD. Four routes will be installed in the routing ta bleE. Two routes will be installed in the routing table
考题
What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?（）A、Route reflectors are not passing updates properly.B、BGP synchronization has been enabled.C、The next-hop address is unreachable.D、No loopback interface has been configured on a router.
考题
What are some of the characteristics of the OSPF routing protocol?（）A、It confines network instability to a single area of network.B、It increases the routing overhead of the networkC、It supports VLSMD、It routes between Autonomous Systems.E、It allows extensive control of routing updatesF、None of the above
考题
While troubleshooting a routing problem on the company EIGRP network you discover that one ofthe routers is failing to establish adjacencies with its neighbor. What is a likely cause of thisproblem between neighbors？（）A、The K-values do not matchB、The hold times do not matchC、The hello times do not matchD、The AS numbers do not match
考题
What is a reason for implementing MPLS in a network？（）A、MPLS eliminates the need of an IGP in the core.B、MPLS reduces the required number of BGP-enabled devices in the core.C、Reduces routing table lookup since only the MPLS core routers perform routing table lookups.D、MPLS eliminates the need for fully meshed connections between BGP enabled devices.
考题
In what location are EIGRP successor routes stored?（）A、In the routing table only.B、In the neighbor table only.C、In the topology table only.D、In the routing table and neighbor table.E、In the routing table and topology table.F、In the topology table and neighbor table.
考题
When attempting to view the OSPF routes in the routing table, you issue the command show route table inet.3 but no OSPF routes are displayed. What is the problem?（）A、The OSPF routes are located in the inet4.0 routing table.B、The OSPF routes are located in the inet.0 routing table.C、The OSPF routes are located in the inet.2 routing table.D、The OSPF routes are located in the inet4.3 routing table.
考题
What is the default import routing policy for OSPF?（）A、Accept all OSPF routes and install them into the inet.3 routing table.B、Accept all OSPF routes and install them into the inet7.0 routing table.C、Accept all OSPF routes and install them into the inet4.0 routing table.D、Accept all OSPF routes and install them into the inet.0 routing table.
考题
What is the most likely reason for the dispartly between the actual network numbers at the branches and the routes in the routing table on Gateway-Router?（）A、Branch-Router2 is configured to send both RIPv1 and RIPv2 updates.B、Gateway-Router is configured to only receive RIPv2 updates.C、Gateway-router is configured to receive only RIPv1 updates.D、Branch-Router1 is configured to only send RIPv1 updates
考题
Which of the following answers is the least likely reason for an engineer to choose to use route redis tribution?（）A、To exchange routes between merged companiesB、To give separate control over routing to different parts of one companyC、To support multiple router vendorsD、To knit together an OSPF area if the area becomes discontiguous
考题
What does a router do if it has no EIGRP feasible successor route to a destination network and the successor route to that destination network is inactive status?（）A、It routes all traffic that is addresses to the destination network to the interface indicates in the routing table.B、It sends a copy of its neighbor table to all adjacent routers.C、It sends a multicast query packet to all adjacent neighbors requesting available routing paths to the destination network.D、It broadcasts Hello packets to all routers in the network to re-establish neighbor adjacencies.
考题
What is the role of route preference?（）A、It is used to determine which route should become active.B、It is used to select which routing table to use for forwarding.C、It is used to determine what routes to accept into the routing table.D、It is used to select the best route between multiple equal cost paths.
考题
What is the role of route preference?（）A、It is used as a tie breaker when the same prefix is available through multiple sourcesB、It is used to determine which routes to accept into the routing tableC、It is used to select the best route between multiple equal-cost pathsD、It is used to select which routing table to use for forwarding
考题
When attepting to view the OSPF routes in the routing table, you issue the command show route table inet but no OSPF routes are displayed. What is the problem?（）A、The OSPF routes are located in the inet 4 routing tableB、THe OSPF routes are located in the inet 0 routing tableC、The OSPF routes are located in the inet 2 routing tableD、The OSPF routes are located in the inet 4.3 routing table
考题
多选题Refer to the exhibit. Which two statements are correct？ （Choose two.）（）AAll six routes will be installed in the routing table.BTwo routes will be installed in the routing table.CFour routes will be installed in the routing table.DAll the routes were redistributed into BGP from an IGP.EAll the routes were originated by BGP with the network command.
考题
单选题What is the role of route preference?（）A
It is used to determine which route should become active.B
It is used to select which routing table to use for forwarding.C
It is used to determine what routes to accept into the routing table.D
It is used to select the best route between multiple equal cost paths.
考题
单选题In what location are EIGRP successor routes stored?（）A
In the routing table only.B
In the neighbor table only.C
In the topology table only.D
In the routing table and neighbor table.E
In the routing table and topology table.F
In the topology table and neighbor table.
考题
单选题When attepting to view the OSPF routes in the routing table, you issue the command show route table inet but no OSPF routes are displayed. What is the problem?（）A
The OSPF routes are located in the inet 4 routing tableB
THe OSPF routes are located in the inet 0 routing tableC
The OSPF routes are located in the inet 2 routing tableD
The OSPF routes are located in the inet 4.3 routing table
考题
单选题When attempting to view the OSPF routes in the routing table, you issue the command show route table inet.3 but no OSPF routes are displayed. What is the problem?（）A
The OSPF routes are located in the inet4.0 routing table.B
The OSPF routes are located in the inet.0 routing table.C
The OSPF routes are located in the inet.2 routing table.D
The OSPF routes are located in the inet4.3 routing table.
考题
单选题What is the most likely reason for the dispartly between the actual network numbers at the branches and the routes in the routing table on Gateway-Router?（）A
Branch-Router2 is configured to send both RIPv1 and RIPv2 updates.B
Gateway-Router is configured to only receive RIPv2 updates.C
Gateway-router is configured to receive only RIPv1 updates.D
Branch-Router1 is configured to only send RIPv1 updates
考题
多选题What are some of the characteristics of the OSPF routing protocol?（）AIt confines network instability to a single area of network.BIt increases the routing overhead of the networkCIt supports VLSMDIt routes between Autonomous Systems.EIt allows extensive control of routing updatesFNone of the above
考题
单选题What is the default import routing for OSPF?（）A
Accept all OSPF routes and install them into the 3 routing tableB
Accept all OSPF routes and install them into the inet7.0 routing tableC
Accept all OSPF routes and install them into the inet4.0 routing tableD
Accept all OSPF routes and install them into the inet.0 routing table
考题
多选题While troubleshooting a routing problem on the company EIGRP network you discover that one ofthe routers is failing to establish adjacencies with its neighbor. What is a likely cause of thisproblem between neighbors？（）AThe K-values do not matchBThe hold times do not matchCThe hello times do not matchDThe AS numbers do not match
考题
多选题Half of your network uses RIPv2 and the other half runs OSPF. The networks do not communicate with each other. Which two of these factors describe the impact of activating EIGRP over each separate part？（）AEIGRP will not be accepted when configured on the actual RIPv2 routers.BOSPF will no longer be used in the routing table， because you only have EIGRP internal routes running.COSPF will no longer be used in the routing table， because you only have EIGRP external routes running.DRIPv2 will populate its RIP database but not its routing table， because you only have EIGRP external routes running.ERIPv2 will populate its RIP database but not its routing table， because you only have EIGRP internal routes running.FOSPF database will have RIPv2 routes.
考题
单选题What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?（）A
Route reflectors are not passing updates properly.B
BGP synchronization has been enabled.C
The next-hop address is unreachable.D
No loopback interface has been configured on a router.
热门标签
最新试卷
