网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
Which statement is true regarding the remote route table of a local WX device?（）
- A、Remote routes are the compression subnets advertised by remote WX devices.
- B、Remote routes include routes for remote hosts or subnets advertised by a WAN router.
- C、Remote routes are the routes advertised by remote routers that are more than two hops away.
- D、Remote routes are the compression subnets advertised by the local WX device to the remote WX devices.
参考答案
更多 “Which statement is true regarding the remote route table of a local WX device?（）A、Remote routes are the compression subnets advertised by remote WX devices.B、Remote routes include routes for remote hosts or subnets advertised by a WAN router.C、Remote routes are the routes advertised by remote routers that are more than two hops away.D、Remote routes are the compression subnets advertised by the local WX device to the remote WX devices.” 相关考题
考题
By default, an L1／L2 IS－IS router advertises what remote area routes into a Level 1 area?()
A. only summarized routesB. all routes in the networkC. all routes in the backboneD. No routes are advertised.
考题
Which statement is true regarding the remote route table of a local WX device?()
A. Remote routes are the compression subnets advertised by remote WX devices.B. Remote routes include routes for remote hosts or subnets advertised by a WAN router.C. Remote routes are the routes advertised by remote routers that are more than two hops away.D. Remote routes are the compression subnets advertised by the local WX device to the remote WX devices.
考题
Which three circumstances would prevent traceroute from displaying the WAN IP addresses? ()(Choose three)
A. The WAN link is down.B. IPSec is enabled on the WX.C. Traceroute is enabled for compression.D. The network is configured using static routes.E. The local and remote cables are accidentally swapped.
考题
Which statement is true about compression subnets?()
A. Compression subnets are turned on by default.B. Compression subnets advertise remote routes.C. Compression subnets are usually LAN-side subnets.D. Compression subnets are usually WAN-side subnets.
考题
A router leams about a remote network from EIGRP.OSPF. and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network?（）A. The router will use the static route.B. The router will use the OSPF route.C. The route will use the EIGRP route.D. The router will load balance and use all three routes.
考题
What are three key concepts that apply when configuring the EIGRP stub routing feature in a hub and spoke network?()
A. A hub router prevents routes from being advertised to the remote router.B. Only remote routers are configured as stubs.C. Stub routers are not queried for routes.D. Spoke routers connected to hub routers answer the route queries for the stub router.E. A stub router should have only EIGRP hub routers as neighbors.F. EIGRP stub routing should be used on hub routers only.
考题
Which three of these are major scaling, sizing, and performance considerations for an IPsec design?()
A. connection speedB. number of remote sitesC. features to be supportedD. types of devices at the remote siteE. whether packets are encrypted using 3DES or AESF. number of routes in the routing table at the remote site
考题
A router learns about a remote network from EIGRP, OSPF, and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network（）。A.The router will use the static route.B.The router will use the OSPF route.C.The router will use the EIGRP route.D.The router will load balance and use all three routes.
考题
A router learns about a remote network from EIGRP, OSPF, and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network（）。A、The router will use the static route.B、The router will use the OSPF route.C、The router will use the EIGRP route.D、The router will load balance and use all three routes.
考题
Which three of these are major scaling， sizing， and performance considerations for an IP secdesign？ （）A、 connection speedB、 number of remote sitesC、 features to be supportedD、 types of devices at the remote siteE、 whether packets are encrypted using 3DES or AESF、 number of routes in the routing table at the remote site
考题
Which statement is true regarding proxy ARP？（）A、Proxy ARP is enabled by default on stand-alone JUNOS security devices.B、Proxy ARP is enabled by default on chassis clusters.C、JUNOS security devices can forward ARP requests to a remote device when proxy ARP is enabled.D、JUNOS security devices can reply to ARP requests intended for a remote device when proxy ARP is enabled
考题
Which three circumstances would prevent traceroute from displaying the WAN IP addresses? （）(Choose three)A、The WAN link is down.B、IPSec is enabled on the WX.C、Traceroute is enabled for compression.D、The network is configured using static routes.E、The local and remote cables are accidentally swapped.
考题
Which three attributes are advertised to the remote PE and BGP-based VPNs？（）A、Circuit IDB、VPN labelC、Route targetD、VPN numberE、Route distinguisher
考题
The sysdumpdev command can be used to configure remote dump devices. Which of the following conditions is NOT used for a remote dump device configuration?（）A、The local and the remote host must have Transmission Control Protocol/Internet Protocol (TCP/IP) installed and configured. B、The remote host must support NFS. C、The remote host must have an NFS exported directory defined such that the local host has read and write permissions to the dump file on the remote host. D、The remote host can be the same as the local host.
考题
By default, an L1/L2 IS-IS router advertises what remote area routes into a Level 1 area?（）A、only summarized routesB、all routes in the networkC、all routes in the backboneD、No routes are advertised.
考题
How do you verify connectivity between the default gateway and a WX device?（）A、Check the WX device remote interface and verify that the status is up.B、From the WX device, ping the default gateway to make sure it is reachable.C、In WebView, check the service tunnel status under Compression Basic Endpoints.D、In WebView, check the remote routes under Compression Advanced Remote Routes.
考题
Which statement is true about compression subnets?（）A、Compression subnets are turned on by default.B、Compression subnets advertise remote routes.C、Compression subnets are usually LAN-side subnets.D、Compression subnets are usually WAN-side subnets.
考题
What are two examples of RE exception traffic?（）A、BGP updates that travel through the local router and are destined for a remote router.B、OSPF hello packets that are sent from a remote router and are destined for the local router.C、Telnet traffic that is sent from a remote host and is destined for the local router.D、Telnet traffic that travels through the local router and is destined for a remote end host.
考题
Which statement is true regarding remote archive log file destinations？（）A、Only two destinations per remote database can be specified.B、Destination is an Oracle Net alias specified by using the SERVICE keyword.C、The REOPEN attribute must be used when using remote archive log file destinations.D、The service name is resolved by searching sqlnet.ora file for the remote database name.
考题
单选题The sysdumpdev command can be used to configure remote dump devices. Which of the following conditions is NOT used for a remote dump device configuration?（）A
The local and the remote host must have Transmission Control Protocol/Internet Protocol (TCP/IP) installed and configured. B
The remote host must support NFS. C
The remote host must have an NFS exported directory defined such that the local host has read and write permissions to the dump file on the remote host. D
The remote host can be the same as the local host.
考题
单选题Which statement is true regarding the remote route table of a local WX device?（）A
Remote routes are the compression subnets advertised by remote WX devices.B
Remote routes include routes for remote hosts or subnets advertised by a WAN router.C
Remote routes are the routes advertised by remote routers that are more than two hops away.D
Remote routes are the compression subnets advertised by the local WX device to the remote WX devices.
考题
单选题A router learns about a remote network from EIGRP, OSPF, and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network（）。A
The router will use the static route.B
The router will use the OSPF route.C
The router will use the EIGRP route.D
The router will load balance and use all three routes.
考题
多选题Which three of these are major scaling, sizing, and performance considerations for an IPsec design?（）Aconnection speedBnumber of remote sitesCfeatures to be supportedDtypes of devices at the remote siteEwhether packets are encrypted using 3DES or AESFnumber of routes in the routing table at the remote site
考题
单选题How do you verify connectivity between the default gateway and a WX device?（）A
Check the WX device remote interface and verify that the status is up.B
From the WX device, ping the default gateway to make sure it is reachable.C
In WebView, check the service tunnel status under Compression Basic Endpoints.D
In WebView, check the remote routes under Compression Advanced Remote Routes.
考题
单选题A router leams about a remote network from EIGRP.OSPF. and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network?（）A
The router will use the static route.B
The router will use the OSPF route.C
The route will use the EIGRP route.D
The router will load balance and use all three routes.
考题
单选题Which statement is true about compression subnets?（）A
Compression subnets are turned on by default.B
Compression subnets advertise remote routes.C
Compression subnets are usually LAN-side subnets.D
Compression subnets are usually WAN-side subnets.
考题
单选题By default, an L1/L2 IS-IS router advertises what remote area routes into a Level 1 area?（）A
only summarized routesB
all routes in the networkC
all routes in the backboneD
No routes are advertised.
热门标签
最新试卷
