网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
On which of the following hard drive types must Bob, a technician, change the jumper setting to match the motherboard/cabling combination?（）
- A、SATA
- B、eSATA
- C、Solid state
- D、PATA
参考答案
更多 “On which of the following hard drive types must Bob, a technician, change the jumper setting to match the motherboard/cabling combination?（）A、SATAB、eSATAC、Solid stateD、PATA” 相关考题
考题
When Bob, a technician, powers up a desktop PC, the unit will repeat three short beeps and will not POST. Which of the following is MOST likely the problem?()
A. The memory is failing.B. The CPU is overheating.C. The hard drive is not attached properly.D. The operating system is not installed.
考题
A technician is upgrading an internal IDE drive in a laptop. Which of the following HDD types is thetechnician MOST likely using?()
A.PATAB.SATAC.Solid stateD.RAID
考题
A technician has lost a necessary jumper for a new hard drive that must be installed immediately.Which of the following is the BEST solution?()
A. Use a jumper from the motherboard where the new drive is going to be installed.B. Use a jumper from a hard drive that is no longer functioning.C. Contact the manufacturer of the new hard drive and have a replacement jumper shipped immediately.D. The new hard drive must be replaced
考题
A PC is powered on and begins POST. The PC takes a long time when scanning for drives. The BIOS reports no hard drive can be found but the CD-ROM is identified. The technician knows that there are two hard drives on the primary EIDE controller and a CD-ROM on the secondary EIDE controller.Which of the following is the MOST likely cause of the problem?（）A. Both hard drives have the master jumper in place.B. One hard drive is set as master and the other slave.C. The hard drive data cable is reversed.D. Both hard drives have the cable select jumper in place.
考题
A technician is installing a new power supply into a computer. One of the power supply connectors that the technician needs to connect to the motherboard is square and contains 4-pins. This connector is known as which of the following?（）A.SATAB.FDDC.IDED.ATX
考题
When Bob, a technician, powers up a desktop PC, the unit will repeat three short beeps and will not POST. Which of the following is MOST likely the problem?（）A、The memory is failing.B、The CPU is overheating.C、The hard drive is not attached properly.D、The operating system is not installed.
考题
A technician has lost a necessary jumper for a new hard drive that must be installed immediately.Which of the following is the BEST solution?（）A、Use a jumper from the motherboard where the new drive is going to be installed.B、Use a jumper from a hard drive that is no longer functioning.C、Contact the manufacturer of the new hard drive and have a replacement jumper shipped immediately.D、The new hard drive must be replaced
考题
A user wants to install an external hard drive using the fastest connection available. Which of the following should the technician recommend?（）A、USB 1.1B、eSATAC、USB 2.0D、IEEE 1394
考题
A PC is powered on and begins POST. The PC takes a long time when scanning for drives. The BIOS reports no hard drive can be found but the CD-ROM is identified. The technician knows that there are two hard drives on the primary EIDE controller and a CD-ROM on the secondary EIDE controller. Which of the following is the MOST likely cause of the problem?（）A、Both hard drives have the master jumper in place.B、One hard drive is set as master and the other slave.C、The hard drive data cable is reversed.D、Both hard drives have the cable select jumper in place.
考题
Which of the following are ways to transport SAN traffic？（）A、 SATAB、 iSCSIC、 SCSID、 Fiber channelE、 PATA
考题
In which of the following locations would a technician set the LBA mode for a hard drive？（）A、Jumper SettingsB、Disk ManagerC、Device ManagerD、System BIOS
考题
After a technician installs a new CMOS battery on a motherboard, which of the following will thetechnician have to change? （）A、Firmware versionB、System date/timeC、Bus speedsD、Jumper settings
考题
A user requires more storage space on their computer. After a technician installs a second IDE drive in the computer, the system will not recognize that there are any hard drives installed. Which of the following is the MOST likely cause of the problem?（）A、The second hard drive has not been formatted for NTFS.B、The jumpers on both drives are set to the cable select position.C、The jumper on the first drive is set to master and the second is set to slave.D、The jumpers on both drives are set to the master position.
考题
Which of the following is eliminated when using SATA instead of PATA technology？（）A、Jumper selectionB、Power connectorC、Data port connectorD、Hard drive LEDs
考题
Which of the following can be used to achieve the highest transfer rate for an external hard drive?（）A、FireWireB、eSATAC、USB1.1D、USB2.0
考题
A technician is installing a new power supply into a computer. One of the power supply connectors that the technician needs to connect to the motherboard is square and contains 4-pins. This connector is known as which of the following?（）A、SATAB、FDDC、IDED、ATX
考题
A technician needs to configure a computer with an external storage drive. Which of the following interfaces would provide the FASTEST throughput?（）A、USB 2.0B、eSATAC、CAT5D、FireWire
考题
Bob, a technician, is adding a secondary IDE hard drive to an older system. After installation and the first boot, the drive is not showing in Disk Management. Which of the following is the MOST likely cause of the issue?（）A、The new drive’s jumper is set for master.B、The new drive is connected to the secondary bus as a slave drive.C、Both drives’ jumpers are set for cable select.D、The old drive’s jumper is set for master and the new drive is set for slave.
考题
A technician is upgrading an internal IDE drive in a laptop. Which of the following HDD types is thetechnician MOST likely using?（）A、PATAB、SATAC、Solid stateD、RAID
考题
Which of the following will allow a technician to extend a partition?（）A、Set the drive up as basicB、Format the drive to FAT32C、Install a second hard driveD、Set the drive as dynamic
考题
A technician installs a SATA controller card and moves the hard drive cable from the system board to the SATA controller. The system POSTs and the controller BIOS recognizes the hard drive but does not boot to the hard drive and start Windows. Which of the following is the MOST likely cause of the problem？（）A、Windows cannot be booted from a controller card.B、The hard drive must have Windows reinstalled because a new controller card was installed.C、The SATA controller card was not set as a boot device in the computer BIOS.D、The new controller must have the correct jumper settings for Windows mode.
考题
A technician is booting up a computer but the computer never moves beyond POST. The floppydisk drive light stays lit continuously during the boot process. Which of the following is the MOST likely cause?（）A、The hard drive is not formatted.B、The BIOS is corrupted.C、The motherboard has faulty capacitors.D、The drive cable is backwards
考题
单选题Bob, a technician, is adding a secondary IDE hard drive to an older system. After installation and the first boot, the drive is not showing in Disk Management. Which of the following is the MOST likely cause of the issue?（）A
The new drive’s jumper is set for master.B
The new drive is connected to the secondary bus as a slave drive.C
Both drives’ jumpers are set for cable select.D
The old drive’s jumper is set for master and the new drive is set for slave.
考题
单选题A user requires more storage space on their computer. After a technician installs a second IDE drive in the computer, the system will not recognize that there are any hard drives installed. Which of the following is the MOST likely cause of the problem?（）A
The second hard drive has not been formatted for NTFS.B
The jumpers on both drives are set to the cable select position.C
The jumper on the first drive is set to master and the second is set to slave.D
The jumpers on both drives are set to the master position.
考题
单选题A technician is booting up a computer but the computer never moves beyond POST. The floppydisk drive light stays lit continuously during the boot process. Which of the following is the MOST likely cause?（）A
The hard drive is not formatted.B
The BIOS is corrupted.C
The motherboard has faulty capacitors.D
The drive cable is backwards
考题
单选题After a technician installs a new CMOS battery on a motherboard, which of the following will thetechnician have to change? （）A
Firmware versionB
System date/timeC
Bus speedsD
Jumper settings
考题
单选题On which of the following hard drive types must Bob, a technician, change the jumper setting to match the motherboard/cabling combination?（）A
SATAB
eSATAC
Solid stateD
PATA
热门标签
最新试卷