网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
The latest SCSI adaptor card is purchased from a vendor. Drivers for the operating system cannot be obtained. The SCSI adapter card is added to an existing server. Upon booting， the operating system does not detect the card. Which of the following is the MOST likely cause of the problem？（）
- A、 The SCSI card is not seated correctly.
- B、 The termination is incorrectly set on the SCSI card.
- C、 The SCSI card is not listed on the operating system HCL （Hardware Compatibility List）.
- D、 Operating system patches were not updated before installing the card.
参考答案
更多 “The latest SCSI adaptor card is purchased from a vendor. Drivers for the operating system cannot be obtained. The SCSI adapter card is added to an existing server. Upon booting， the operating system does not detect the card. Which of the following is the MOST likely cause of the problem？（）A、 The SCSI card is not seated correctly.B、 The termination is incorrectly set on the SCSI card.C、 The SCSI card is not listed on the operating system HCL （Hardware Compatibility List）.D、 Operating system patches were not updated before installing the card.” 相关考题
考题
SCSI是一种计算机系统的通用输入输出接口标准。SCSI接口常用来连接(41)设备，一条SCSI总线可连接多至(42)台SCSI设备。SCSI I的最大同步传输速率(43)MB/s。SCSI Ⅱ定义了2种提高速度的选择：Fast SCSI和Wide SCSI。数据通路为8位的Fast SCSI的最大同步传输速率为(44)MB/s，数据通路为16位的Wide SCSI的最大同步传输率为(45)MB/s。A．鼠标器B．键盘C．显示器D．硬盘
考题
Click on the Exhibit button. Which of the following connectors is image D?()
A. 80 Pin SCSI ConnectorB. 68 Pin SCSI Connector, High DensityC. 50 Pin SCSI Connector, High DensityD. 50 Pin SCSI Connector, Low Density
考题
关于SCSI,下列说法正确的是( )A.SCSI包括SCSI控制器和SCSI设备B.SCSI控制器也称做主机适配器C.SCIS控制器位于SCSI设备中D.SCIS控制器作为插卡或一个电路单元而位于主板处
考题
Which command enables new devices that are connected to the scsi5 adapter without performing a full scan of the system?()
A.cfgmgr -f scsi5B.cfgmgr -i scsi5C.cfgmgr -t scsi5D.cfgmgr -l scsi5
考题
SCSI总线上可连接7或15个设备，它们是靠给设备分ID号来区分的，并通过（）对SCSI设备进行设置。A、系统BIOS中B、SCSI控制器中的BIOSC、SCSI设备上的跳线D、SCSI设备在电缆上的位置
考题
关于SCSI，下列说法正确的是（）A、SCSI包括SCSI控制器和SCSI设备B、SCSI控制器也称做主机适配器C、SCIS控制器位于SCSI设备中D、SCIS控制器作为插卡或一个电路单元而位于主板处
考题
An Ultra 160 or Ultra 320 device falls under which SCSI standard？（）A、SCSI-1B、SCSI-3C、SCSI-2D、SCSI-4
考题
Click on the Exhibit button. Which of the following connectors is image D?（）A、80 Pin SCSI ConnectorB、68 Pin SCSI Connector, High DensityC、50 Pin SCSI Connector, High DensityD、50 Pin SCSI Connector, Low Density
考题
Companycom is implementing a pair of Virtual IO Servers to service four LPARs. If each operating system image requires 15GB of disk space, what is the minimum amount of SCSI resource necessary?（）A、Two SCSI paths and two 73GB SCSI disksB、Two SCSI paths and two 36GB SCSI disksC、Four SCSI paths and four 73GB SCSI disksD、Two dual port SCSI RAID adapters with two 73GB SCSI disks
考题
SATA RAID比较于SCSI RAID的一个优势是？（）A、SATA RAID成本上要低于SCSI RAIDB、SATA RAID性能上要优于SCSI RAIDC、SATA RAID支持RAID5，SCSI RAID不支持RAID5D、SATA RAID速度上要快于SCSI RAID
考题
以下关于FC协议和SCSI协议的关系描述错误的是？（）A、FC可以通过构建帧来传输SCSI指令、数据和状态信息单元B、FC或者iSCSI协议是用来承载SCSI协议的，是对SCSI协议的一种扩展C、SCSI是FC4的上层协议，SCSI是FC协议的子集D、FC是SCSI的替代
考题
A technician needs to install the first SCSI controller in an application server. The SCSI card is factory-configured with a SCSI ID of 1. Which SCSI ID should the technician configure the card before installation？（）A、 0B、 1C、 4D、 7
考题
An administrator has just finished physically replacing the system board in a Windows domain controller. Which of the following must be done before booting the server back into Windows?（）A、Update the time and date in the BIOS.B、Update the firmware on the SCSI controller.C、Update the firmware to the latest version.D、Configure IPMI on the new board.
考题
Which command enables new devices that are connected to the scsi5 adapter without performing a full scan of the system?（）A、cfgmgr -f scsi5B、cfgmgr -i scsi5C、cfgmgr -t scsi5D、cfgmgr -l scsi5
考题
An administrator suspects problems on a SCSI hard disk, but upon running diagnostics, no errors were found. What must be done to check the condition of the drive?（）A、Run diag and select the 'Certify Media' task.B、Perform a read and write test on the disk and monitor errorlog.C、Update the disk firmware to the latest level and monitor errorlog.D、Format the disk to ensure bad blocks are omitted from the disk layout.
考题
单选题You install Windows 2000 Professional onto an NTFS partition on your computer. During theinstallation, you manually specify the OEM driver for the tape device SCSI controller. After theinstallation, you run the Winnt32 /cmdcons command. Then you successfully install the latest Windows2000 service pack.Next, you install an updated driver for the tape device SCSI controller. When you restart the system andlog on to the computer, you receive a stop error.You need to restore the functionality of the SCSI controller with the least amount of administrative effort. What should you do? （）A
Restart the computer in Safe Mode. Reinstall the functional SCSI controller driver. B
Restart the computer into Recovery Console. Replace the faulty SCSI controller driver with the functional one. C
Start the computer by using a Windows 2000 Professional disk. Replace the faulty SCSI controller driver with the functional one. D
Install a parallel copy of Windows 2000 Professional in a separate folder. Copy the functional SCSI controller driver into the original system folder, and restart the computer to the previous installation.
考题
单选题Click on the Exhibit button. Which of the following connectors is image D?（）A
80 Pin SCSI ConnectorB
68 Pin SCSI Connector, High DensityC
50 Pin SCSI Connector, High DensityD
50 Pin SCSI Connector, Low Density
考题
单选题The latest SCSI adaptor card is purchased from a vendor. Drivers for the operating system cannot be obtained. The SCSI adapter card is added to an existing server. Upon booting， the operating system does not detect the card. Which of the following is the MOST likely cause of the problem？（）A
The SCSI card is not seated correctly.B
The termination is incorrectly set on the SCSI card.C
The SCSI card is not listed on the operating system HCL （Hardware Compatibility List）.D
Operating system patches were not updated before installing the card.
考题
单选题An administrator has just finished physically replacing the system board in a Windows domain controller. Which of the following must be done before booting the server back into Windows？（）A
Update the time and date in the BIOS.B
Update the firmware on the SCSI controller.C
Update the firmware to the latest version.D
Configure IPMI on the new board.
热门标签
最新试卷
