网友您好, 请在下方输入框内输入要搜索的题目:
题目内容
(请给出正确答案)
After the LED display is flashing 888 and the system is rebooted, which of the following commands should be used to gather dump information?()
- A、snap
- B、errpt
- C、kdb
- D、trace
参考答案
更多 “After the LED display is flashing 888 and the system is rebooted, which of the following commands should be used to gather dump information?()A、snap B、errpt C、kdb D、trace” 相关考题
考题
关于LD和LED,以下说法正确的是()。
A.一般LD与光纤的藕合效率比LED高B.LED属于阀值器件C.LED主要靠受激辐射效应发光D.由于LED的线性比LD好,因此LED更适合高速传输系统
考题
SS4型电力机车牵引控制柜中电压调节板测试:反馈信号置“电流”位,测电流给定电路,观察负载波形,三段桥应顺序开通平滑,此时()。A、LED1灭、LED2灭B、LED1灭、LED2亮C、LED1亮、LED2灭D、LED1亮、LED2亮
考题
假如你有纽扣电池1个,LED(发光二极管)1枚,以下哪种电路连接方法能成功点亮LED?()A、LED的正极连接到电池的负极,LED的负极连接到电池的正极B、LED的正极连接到电池的正极,LED的负极连接到电池的负极C、将LED的正负极连接在一起,再连接到电池的正极D、以上都不对
考题
关于LD和LED,以下说法正确的是()。A、一般LD与光纤的藕合效率比LED高B、LED属于阀值器件C、LED主要靠受激辐射效应发光D、由于LED的线性比LD好,因此LED更适合高速传输系统
考题
单选题After World War I political unrest in Britain led to()general elections in just over 5 years.A
2B
3C
4D
5
考题
单选题使用CC2430控制的LED共有6个,其中LED1,LED2为阳极控制(高电平点亮),LED3-LED6为阴极控制(低电平点亮),对应I/O引脚关系为P1.0-Led1P1.0--Led1,当需要LED1、LED3点亮,其余熄灭时,P1寄存器的值应设为()。A
0x14B
0x05C
0x9CD
0x39
考题
单选题使用CC2430控制的LED共有6个,其中LED1,LED2为阳极控制(高电平点亮),LED3-LED6为阴极控制(低电平点亮),对应I/O引脚关系为P1.0--Led1,当需要LED6、LED4点亮,其余熄灭时,P1寄存器的值应设为()。A
0x50B
0x3CC
0x14D
0x0A
考题
单选题Which mooring line prevents sideways motion of a vessel moored to a pier().A
A line led forward from the bowB
A line led aft from the bowC
A line led in the same direction as the keelD
A line led at a right angle to the keel
热门标签
最新试卷