网友您好, 请在下方输入框内输入要搜索的题目:

题目内容 (请给出正确答案)
单选题
When configuring a multipoint GRE (mGRE) tunnel interface, which one of the following is NOT a valid configuration option:()
A

 tunnel source

B

 tunnel destination

C

 tunnel key

D

 ip address

E

 tunnelvrf


参考答案

参考解析
解析: 暂无解析
更多 “单选题When configuring a multipoint GRE (mGRE) tunnel interface, which one of the following is NOT a valid configuration option:()A  tunnel sourceB  tunnel destinationC  tunnel keyD  ip addressE  tunnelvrf” 相关考题
考题 根据网络拓扑和需求说明,解释路由器R2的GRE隧道配置。……R2(config)interface tunnel 0 (启用tunnel 0 )R2(config-if)tunnel source sl/0 (9)R2(config-iotunnel destination 200.100.1.1 (10)R2(config-if)ipv6 address 2000:2fcc::2/64 (为tunnel配置IM地址)R2(config-if)tunnel mode gre ipv6 (11)(9)

考题 Router R1, a branch router, connects to the Internet using DSL. Some traffic flows through a GRE and IPsec tunnel, over the DSL connection, destined for an Enterprise network.Which of the following answers best describes the router‘s logic that tells the router, for a given packet, to apply GRE encapsulation to the packet?()A. When the packet received on the LAN interface is permitted by the ACL listed on the tunnel greacl command under the incoming interfaceB. When routing the packet, matching a route whose outgoing interface is the GRE tunnel interfaceC. When routing the packet, matching a route whose outgoing interface is the IPsec tunnel interfaceD. When permitted by an ACL that was referenced in the associated crypto map

考题 The following configura tion exists on a router on one end of an IPv6 tunnel. Which type of tunnel is created by this configuration?()interface loopback 1ip address 1.1.1.1 255.255.255.255interface tunnel 2ipv6 address 2000::1::/64tunnel source loopback 1tunnel destina tion 2.2.2.2tunnel mode ipv6ipipv6 eigrp 1A. Automatic 6to4B. Manually configured tunnelC. ISATAPD. GRE

考题 Refer to the exhibit. A new TAC engineer came to you for advice. A GRE over IPsec tunnel was configured, but the tunnel is not coming up. W hat did the TAC engineer configure incorrectly?() A. The crypto isakmp configuration is not correct.B. The crypto map configuration is not correct.C. The interface tunnel configuration is not correct.D. The network configuration is not correct; netw ork 172.16.1.0 is missing.

考题 In which tunnel-less VPN topology do group members register with a key server in order to receivethe security association necessary to communicate with the group?()A、 Easy VPNB、 GRE tunnelingC、 Virtual Tunnel InterfacesD、 Dynamic Multipoint VPNE、 Group Encrypted Transport VPN

考题 A GRE tunnel is configured between a local and a remote site. Where should the service policy be applied to classify packets based on the pretunnel header? ()A、in global configuration mode, apply the service policy and use the qos pre-classifyB、in global configuration mode, apply the service policy but do not use the qos pre-classify commandC、apply the service policy on the physical interface but do not use the qos pre-classifyD、apply the service policy on the tunnel interface but do not use the qos pre-classify command E、apply the service policy on the tunnel interface and use the qos pre-classify command

考题 Which two statements or sets of statements are true about the application of the qos pre-classify command?()A、 If the classification policy is based upon the ToS byte, the qos pre-classify command is required because the ToS byte only appears in the inner IP header.B、 The ToS byte is copied to the outer header by default. Therefore, the qos pre-classify command is not necessary.C、 With GRE encapsulation, the qos pre-classify command is applied on the tunnel interface. This practice allows for different OoS configurations on each tunnel.D、 With GRE encapsulation, the qos pre-classify command is applied on the physical interface. This practice allows for different OoS configurations on each interface.E、 With IPsec encapsulation, the qos pre-classify command is applied on the physical interface. This practice allows for different OoS configurations on each interface.

考题 Router R1, a branch router, connects to the Internet using DSL. Some traffic flows through a GRE and IPsec tunnel, over the DSL connection, destined for an Enterprise network. Which of the following answers best describes the router's logic that tells the router, for a given packet, to apply GRE encapsulation to the packet?()A、When the packet received on the LAN interface is permitted by the ACL listed on the tunnel greacl command under the incoming interfaceB、When routing the packet, matching a route whose outgoing interface is the GRE tunnel interfaceC、When routing the packet, matching a route whose outgoing interface is the IPsec tunnel interfaceD、When permitted by an ACL that was referenced in the associated crypto map

考题 When configuring a multipoint GRE (mGRE) tunnel interface, which one of the following is NOT a valid configuration option:()A、 tunnel sourceB、 tunnel destinationC、 tunnel keyD、 ip addressE、 tunnelvrf

考题 When configuring a serial interface on a router, what is the default encapsulation?()A、atm-dxiB、frame-relayC、hdlcD、lapbE、ppp

考题 You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec, which two parameters are required when defining the tunnel interfaceinformation?()A、The crypto ACL numberB、The IPSEC mode (tunnel or transport)C、The GRE tunnel interface IP addressD、The GRE tunnel source interface or IP address, and tunnel destination IP addressE、The MTU size of the GRE tunnel interface

考题 在GRE Tunnel接口视图下,配置隧道封装模式为GRE的完整命令为()。A、tunnel protocol greB、tunnel greC、tunnel-protocol greD、protocol gre

考题 The following configura tion exists on a router on one end of an IPv6 tunnel. Which type of tunnel is created by this configuration?() interface loopback 1 ip address 1.1.1.1 255.255.255.255 interface tunnel 2 ipv6 address 2000::1::/64 tunnel source loopback 1 tunnel destina tion 2.2.2.2 tunnel mode ipv6ip ipv6 eigrp 1A、Automatic 6to4B、Manually configured tunnelC、ISATAPD、GRE

考题 What is the advantage of using a multipoint interface instead of point-to-point subinterfaces when configuring a Frame Relay hub in a hub-and-spoke topology?()A、it avoids split-horizon issues with distance vector routing protocols.B、IP addresses can be conserved if VLSM is not being used for subnetting.C、A multipoint interface offers greater security compared to point-to-point subinterface configurations.D、The multiple IP network addresses required for a multipoint interface provide greater addressing flexibility over point-to-point configurations.

考题 The following configuration exists on a router on one end of an IPv6 tunnel. Although the configuration added so far is correct, the configuration is incomplete. Which type of tunnel is most likely to be intended by the network engineer?() interface loopback 1 ip address 192.168.1.1 255.255.255.255 interface tunnel 2 ipv6 address 2002:C0A8:10 1::1/64 tunnel source loopback 1A、Automatic 6to4B、Manually configured tunnelC、ISATAPD、GRE

考题 Which two steps below should you perform on the hub router while configuring EIGRP routing over  DMVPN (mGRE tunnel)? ()A、Set the NHRP hold time to match the EIGRP hold timeB、Add the enable eigrp stub commandC、Add the disable eigrp as-member split-horizon commandD、Add the disable eigrp as-member next-hop-self command

考题 What must be set correctly when configuring a serial interface so that higher-level protocols calculate the best route?()A、bandwidthB、delayC、loadD、reliability

考题 When configuring an explicit path, what does the next-address entry identify?()A、the tunnel end pointB、the tunnel start pointC、a specific node to be traversedD、the node prior to the tunnel end point

考题 Regarding secure tunnel (st) interfaces, which statement is true?()A、You cannot assign st interfaces to a security zone.B、You cannot apply static NAT on an st interface logical unit.C、st interfaces are optional when configuring a route-based VPND、A static route can reference the st interface logical unit as the next-hop

考题 A route-based VPN is required for which scenario?()A、when the remote VPN peer is behind a NAT deviceB、when multiple networks need to be reached across the tunnel and GRE cannot be usedC、when the remote VPN peer is a dialup or remote access clientD、when a dynamic routing protocol is required across the VPN and GRE cannot be used

考题 单选题What is the advantage of using a multipoint interface instead of point-to-point subinterfaces when configuring a Frame Relay hub in a hub-and-spoke topology?()A it avoids split-horizon issues with distance vector routing protocols.B IP addresses can be conserved if VLSM is not being used for subnetting.C A multipoint interface offers greater security compared to point-to-point subinterface configurations.D The multiple IP network addresses required for a multipoint interface provide greater addressing flexibility over point-to-point configurations.

考题 多选题You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec, which two parameters are required when defining the tunnel interfaceinformation?()AThe crypto ACL numberBThe IPSEC mode (tunnel or transport)CThe GRE tunnel interface IP addressDThe GRE tunnel source interface or IP address, and tunnel destination IP addressEThe MTU size of the GRE tunnel interface

考题 单选题When configuring an explicit path, what does the next-address entry identify?()A the tunnel end pointB the tunnel start pointC a specific node to be traversedD the node prior to the tunnel end point

考题 单选题When configuring a serial interface on a router, what is the default encapsulation?()A atm-dxiB frame-relayC hdlcD lapbE ppp

考题 单选题Router R1, a branch router, connects to the Internet using DSL. Some traffic flows through a GRE and IPsec tunnel, over the DSL connection, destined for an Enterprise network. Which of the following answers best describes the router's logic that tells the router, for a given packet, to apply GRE encapsulation to the packet?()A When the packet received on the LAN interface is permitted by the ACL listed on the tunnel greacl command under the incoming interfaceB When routing the packet, matching a route whose outgoing interface is the GRE tunnel interfaceC When routing the packet, matching a route whose outgoing interface is the IPsec tunnel interfaceD When permitted by an ACL that was referenced in the associated crypto map

考题 多选题Cisco AutoQoS takes the interface type and bandwidth into consideration when configuring which three QoS features?()Avoice compression methodologyBLLQCCRTPDrouting protocolELFIFtrust boundary

考题 单选题In which tunnel-less VPN topology do group members register with a key server in order to receivethe security association necessary to communicate with the group?()A  Easy VPNB  GRE tunnelingC  Virtual Tunnel InterfacesD  Dynamic Multipoint VPNE  Group Encrypted Transport VPN