网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
多选题
What are two characteristics of SLB router mode?（）
A
The design supports multiple server subnets.
B
An end-user sees the IP address of the real server.
C
SLB routes between the outside and inside subnets.
D
The source or destination MAC address is rewritten, but the IP addresses left alone.
E
SLB acts as a bump in the wire between servers and upstream firewall or Layer 3 devices.
参考答案
参考解析
解析：
暂无解析
更多 “多选题What are two characteristics of SLB router mode?（）AThe design supports multiple server subnets.BAn end-user sees the IP address of the real server.CSLB routes between the outside and inside subnets.DThe source or destination MAC address is rewritten, but the IP addresses left alone.ESLB acts as a bump in the wire between servers and upstream firewall or Layer 3 devices.” 相关考题
考题
What will cause a Ezonexam router to enter setup mode? (Choose two)A. The configuration file is missing in NVRAM.B. The configuration register is set to 0x2100.C. Boot system commands are misconfigured in the running-configuration.D. The setup command was issued from the privileged mode prompt.E. The IOS is missing.F. The IOS is corrupt.
考题
What are two instances when a WX device route carves? ()(Choose two.)
A. It occurs every 29 hours.B. Packet interception mode is enabled.C. The host is unreachable on the local subnet.D. The subnet is unreachable using the advertised router.
考题
Which two characteristics are true of a firewall running in routed mode based on the following information?()
A. FWSM routes traffic between the VLANs.B. FWSM switches traffic between the VLANs.C. Routed mode is often called bump-in-the-wire mode.D. Routed mode firewall deployments are used most often in current designs.
考题
A network administrator changes the configuration register to 0x2142 and reboots the router. What are two results of making this change?()
A. The IOS image will be ignored.B. The router will prompt to enter initial configuration mode.C. The router will boot to ROM.D. Any configuration entries in NVRAM will be ignored.E. The configuration in flash memory will be booted.
考题
Refer to the exhibit. For what two reasons has the router loaded its IOS image from the location that is shown? ()
A.Router1 has specific boot system command that instruct it to load IOS from TFTP server.B.Router1 is acting as a TFTP server for other routers.C.Router1 cannot locate a valid IOS image in flash memory.D.Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.E.Cisco routers will first attempt to load a image from TFTP for management purposes.
考题
What are two characteristics of a switch that is configured as a VTP client?()
A.if a switch that is configured to operate in client mode cannot access a VTP server,then the switch reverts to transparent mode.B.The local vlan configuration is updated only when an update that has a higher configuration revision number is received.C.Vtp advertisements are not forwarded to neighboring switches that are configured in vtp transparent mode.D.When switches in vtp client mode are rebooted,they send a vtp advertisement request to the vtp servers.E.Vtp client is the default vtp modeF.On switches that are configured to operate in client mode ,vlans can be created,deleted,or renamed locally
考题
What are two characteristics of Telnet (Choose two.)()。
A.Itsendsdataincleartextformat.B.ItisnolongersupportedonCisconetworkdevices.C.ItismoresecurethanSSHD.Itrequiresanenterpriselicenseinordertobeimplemented.E.ItrequiresthatthedestinationdevicebeconfiguredtosupportTelnetconnections.
考题
What are two characteristics of Telnet (Choose two.)（）。A、Itsendsdataincleartextformat.B、ItisnolongersupportedonCisconetworkdevices.C、ItismoresecurethanSSHD、Itrequiresanenterpriselicenseinordertobeimplemented.E、ItrequiresthatthedestinationdevicebeconfiguredtosupportTelnetconnections.
考题
What are two characteristics of Server Load Balancing router mode？（）A、 The design supports multiple server subnets Cisco 642-874： Practice ExamB、 An end-user sees the IP address of the real serverC、 SLB routes between the outside and inside subnetsD、 The source or destination MAC address is rewritten， but the IP addresses left aloneE、 SLB acts as a "bump in the wire" between servers and upstream firewall or Layer 3 devices
考题
What is the purpose of pressing the Ctrl+Break keys during the router password recover procedure?（）A、To restart the router.B、To bypass the configuration in Flash.C、To view the password before changes are made.D、To bypass setup configuration mode.E、To access ROM Monitor mode.
考题
A network administrator changes the configuration register to 0x2142 and reboots the router. What are two results of making this change?（）A、The IOS image will be ignored.B、The router will prompt to enter initial configuration mode.C、The router will boot to ROM.D、Any configuration entries in NVRAM will be ignored.E、The configuration in flash memory will be booted.
考题
What are two characteristics of the SLB One-arm mode？ （）A、 It is not as common as bridge modeB、 The MSFC is not directly connected to the CSMC、 Outbound traffic from servers may need to be directed by PBR or CSNAT to the CSMD、 The SLB is moved to a position where selected inbound and outbound server traffic goesthrough the SLBE、 The CSM statically routes inbound server traffic to the aggregation switch FWSM， then to the connected server subnet
考题
As an experienced technician， you are responsible for Technical Support. Which of the followingdescriptions is correct about the characteristic of SLB one arm mode？（）A、 This out-of-band approach supports scalingB、 SLB· is not inline.C、 Mode is not as common as bridge or routed mode.D、 Return traffic requires PB·R， server default gateway pointing to SLB·， or client source NAT·
考题
What are two instances when a WX device route carves? （）(Choose two.)A、It occurs every 29 hours.B、Packet interception mode is enabled.C、The host is unreachable on the local subnet.D、The subnet is unreachable using the advertised router.
考题
You have a Bridged 1483 service offering where each ATM PVC is assigned a /30 subnet. What are two characteristics of this configuration？（）A、It burns IP addresses.B、It conserves IP addresses.C、Both the client and the ERX Edge Router have IP addresses.D、The client has an IP address， but the ERX Edge Router uses an unnumbered address.
考题
What are two characteristics of OER？ （）A、 It can take on HSRP， VRRP， and GLBP as clients.B、 It provides automatic inbound route optimization.C、 Path selection may be based on delay， loss， or jitter.D、 The border router makes decisions about which outbound path to use.E、 Automatic load distribution is provided for multiple connections.
考题
What are two characteristics of SLB router mode?（）A、The design supports multiple server subnets.B、An end-user sees the IP address of the real server.C、SLB routes between the outside and inside subnets.D、The source or destination MAC address is rewritten, but the IP addresses left alone.E、SLB acts as a "bump in the wire" between servers and upstream firewall or Layer 3 devices.
考题
多选题What are two characteristics of Server Load Balancing router mode？（）AThe design supports multiple server subnets Cisco 642-874： Practice ExamBAn end-user sees the IP address of the real serverCSLB routes between the outside and inside subnetsDThe source or destination MAC address is rewritten， but the IP addresses left aloneESLB acts as a bump in the wire between servers and upstream firewall or Layer 3 devices
考题
多选题What are two characteristics of the SLB One-arm mode？ （）AIt is not as common as bridge modeBThe MSFC is not directly connected to the CSMCOutbound traffic from servers may need to be directed by PBR or CSNAT to the CSMDThe SLB is moved to a position where selected inbound and outbound server traffic goesthrough the SLBEThe CSM statically routes inbound server traffic to the aggregation switch FWSM， then to the connected server subnet
考题
多选题What are two characteristics of a switch that is configured as a VTP client？（）Aif a switch that is configured to operate in client mode cannot access a VTP server，then the switch reverts to transparent mode.BThe local vlan configuration is updated only when an update that has a higher configuration revision number is received.CVtp advertisements are not forwarded to neighboring switches that are configured in vtp transparent mode.DWhen switches in vtp client mode are rebooted，they send a vtp advertisement request to the vtp servers.EVtp client is the default vtp modeFOn switches that are configured to operate in client mode ，vlans can be created，deleted，or renamed locally
考题
多选题What are two characteristics of OER? （）AIt can take on HSRP, VRRP, and GLBP as clients.BIt provides automatic inbound route optimization.CPath selection may be based on delay, loss, or jitter.DThe border router makes decisions about which outbound path to use.EAutomatic load distribution is provided for multiple connections.
考题
多选题You have a Bridged 1483 service offering where each ATM PVC is assigned a /30 subnet. What are two characteristics of this configuration？（）AIt burns IP addresses.BIt conserves IP addresses.CBoth the client and the ERX Edge Router have IP addresses.DThe client has an IP address， but the ERX Edge Router uses an unnumbered address.
考题
单选题As an experienced technician， you are responsible for Technical Support. Which of the followingdescriptions is correct about the characteristic of SLB one arm mode？（）A
This out-of-band approach supports scalingB
SLB· is not inline.C
Mode is not as common as bridge or routed mode.D
Return traffic requires PB·R， server default gateway pointing to SLB·， or client source NAT·
考题
多选题What are two instances when a WX device route carves? （）(Choose two.)AIt occurs every 29 hours.BPacket interception mode is enabled.CThe host is unreachable on the local subnet.DThe subnet is unreachable using the advertised router.
考题
多选题A network administrator changes the configuration register to 0x2142 and reboots the router. What are two results of making this change?（）AThe IOS image will be ignored.BThe router will prompt to enter initial configuration mode.CThe router will boot to ROM.DAny configuration entries in NVRAM will be ignored.EThe configuration in flash memory will be booted.
考题
多选题What are two characteristics of Telnet (Choose two.)（）。AItsendsdataincleartextformat.BItisnolongersupportedonCisconetworkdevices.CItismoresecurethanSSHDItrequiresanenterpriselicenseinordertobeimplemented.EItrequiresthatthedestinationdevicebeconfiguredtosupportTelnetconnections.
热门标签
最新试卷
