网友您好， 请在下方输入框内输入要搜索的题目：

题目内容 （请给出正确答案）

下列（）状态是不可能在路由器的串行端口状态见到的。

  • A、 Interface is up， line protocol is up
  • B、 Interface is down， line protocol is down
  • C、 Interface is down， line protocol is up
  • D、 Interface is up， line protocol is down

参考答案

更多 “下列（）状态是不可能在路由器的串行端口状态见到的。A、 Interface is up， line protocol is upB、 Interface is down， line protocol is downC、 Interface is down， line protocol is upD、 Interface is up， line protocol is down” 相关考题
考题 如果链路的一端被管理DOWN,你将看到的另一端接口状态输出信息是() A.interface is down，line protocol is downB.interface is down，line protocol is upC.interface is up，line protocol is downD.interface is up，line protocol is up
查看答案
考题 An administrator issues the show ip interface s0/0 command and the output displays that interface Serial0/0 is up, line protocol is up.What does "line protocol is up" specifically indicate about the interface?A．The cable is attached properly.B．CDP has discovered the connected device.C．Keepalives are being received on the interface.D．A carrier detect signal has been received from the connected device.E．IP is correctly configured on the interface.
查看答案
考题 Which line from the output of the show ip interface command indicates that there is a Layer 1 problem?A．Serial0/1 is up, line protocol is downB．Serial0/1 is down, line protocol is downC．Serial0/1 is up, line protocol is upD．Serial0/1 is administratively down, line protocol is downE．None of the above
查看答案
考题 While logged into a router you manually shut down the serial 0 interface using the "shutdown" interface configuration command. You then issue the "show interface serial 0" command in exec mode. What could you expect the status of the serial 0 interface to be?（）A. Serial 0 is up, line protocol is upB. Serial 0 is up, line protocol is downC. Serial 0 is down, line protocol is downD. Serial 0 is down, line protocol is upE. Serial 0 is administratively down, line protocol is downF. Serial 0 is administratively down, line protocol is up
查看答案
考题 Part of the configuration files for routers testking1 and testking2 are displayed below:If you were to enter the show interface serial 0 command on router testking1,which of the following will be displayed?（）A. Serial 0 is down, line protocol is downB. Serial 0 is up, line protocol is upC. Open: IPCP, CDPCPD. LCP closedE. LCP open
查看答案
考题 Which line from the output of the show ip interface command indicates a layer 1 problem?() A. Serial0/1 is up, line protocol is downB. Serial0/1 is down, line protocol is downC. Serial0/1 is up, line protocol is upD. Serial0/1 is administratively down, line protocol is down
查看答案
考题 Refer to the exhibit.What is the reason that the interface status is “administratively down,line protocol down”?() A.There is a mismatch in encapsulation typesB.The wrong type of cable is connected to the interfaceC.The interface has been configured with the shutdown commandD.The interface is not receiving any keepalivesE.The interface needs to be configured as a DTE deviceF.There is no encapsulation type configured
查看答案
考题 当学生A用两台Star—R2624路由器在做路由器广域网口连通实验时误将本端口路由器V.35线缆的插头插倒了。结果发现PING直连的路由器不通,请问此时需要查看路由器的状态应该是() A.Serial 0 is up，line protocol is downB.Serial 0 is down，line protocol is downC.Serial 0 is down，line protocol is upD.Serial 0 is administratively down，line protocol is
查看答案
考题 当用户端cisco路由器上用showinterface命令时line和lineprotocal可能出现的几种组合?()。 A.line down；line protocol downB.line down；line protocolC.line up；line protocol downD.line up；line protocol up
查看答案
考题 While logged into a router you manually shut down the serial 0 interface using the "shutdown" interface configuration command. You then issue the "show interface serial 0" command in exec mode. What could you expect the status of the serial 0 interface to be?（）A、Serial 0 is up, line protocol is upB、Serial 0 is up, line protocol is downC、Serial 0 is down, line protocol is downD、Serial 0 is down, line protocol is upE、Serial 0 is administratively down, line protocol is downF、Serial 0 is administratively down, line protocol is up
查看答案
考题 路由器出现Serial interface-number is up，line protocol is down（DTE）的状态，可能出现的问题不包括（）。A、本地或远程路由器配置丢失B、线路故障C、CSU/DSU故障D、LINE未与CSU/DSU联接
查看答案
考题 如果执行了show interface serial 0命令而且出现了消息“Serial line is up，line protocol is up”，对于这条消息的正确解释是什么？（）A、链路正在接收和发送数据B、路由器已经正确配置了本地管理接口C、连接处于激活状态
查看答案
考题 A user has no network connectivity. A check of the associated port indicates that the interface is up， the line protocol is down. Which item would most likely cause this problem？（）A、Speed mismatchB、Incorrect encapsulationC、MTU set too lowD、Duplex mismatch
查看答案
考题 TDCS中使用show interface命令查看路由器接口如显示line Protocol is down说明（）。A、接口故障B、接口正常C、协议正常D、协议故障
查看答案
考题 当学生A用两台Star—R2624路由器在做路由器广域网口连通实验时误将本端口路由器V.35线缆的插头插倒了。结果发现PING直连的路由器不通，请问此时需要查看路由器的状态应该是（）A、Serial 0 is up，line protocol is downB、Serial 0 is down，line protocol is downC、Serial 0 is down，line protocol is upD、Serial 0 is administratively down，line protocol is
查看答案
考题 当用户端cisco路由器上用showinterface命令时line和lineprotocal可能出现的几种组合？（）。A、line down；line protocol downB、line down；line protocolC、line up；line protocol downD、line up；line protocol up
查看答案
考题 Refer to the exhibit.What is the reason that the interface status is “administratively down,line protocol down”?（）A、There is a mismatch in encapsulation typesB、The wrong type of cable is connected to the interfaceC、The interface has been configured with the shutdown commandD、The interface is not receiving any keepalivesE、The interface needs to be configured as a DTE deviceF、There is no encapsulation type configured
查看答案
考题 Which line from the output of the show ip interface command indicates a layer 1 problem?（）A、Serial0/1 is up, line protocol is downB、Serial0/1 is down, line protocol is downC、Serial0/1 is up, line protocol is upD、Serial0/1 is administratively down, line protocol is down
查看答案
考题 如果链路的一端被管理DOWN，你将看到的另一端接口状态输出信息是（）A、interface is down，line protocol is downB、interface is down，line protocol is upC、interface is up，line protocol is downD、interface is up，line protocol is up
查看答案
考题 单选题路由器出现Serial interface-number is up，line protocol is down（DTE）的状态，可能出现的问题不包括（）。A 本地或远程路由器配置丢失B 线路故障C CSU/DSU故障D LINE未与CSU/DSU联接
查看答案
考题 单选题当学生A用两台Star—R2624路由器在做路由器广域网口连通实验时误将本端口路由器V.35线缆的插头插倒了。结果发现PING直连的路由器不通，请问此时需要查看路由器的状态应该是（）A Serial 0 is up，line protocol is downB Serial 0 is down，line protocol is downC Serial 0 is down，line protocol is upD Serial 0 is administratively down，line protocol is
查看答案
考题 多选题当用户端cisco路由器上用showinterface命令时line和lineprotocal可能出现的几种组合？（）。Aline down；line protocol downBline down；line protocolCline up；line protocol downDline up；line protocol up
查看答案
考题 单选题TDCS中使用show interface命令查看路由器接口如显示line Protocol is down说明（）。A 接口故障B 接口正常C 协议正常D 协议故障
查看答案
考题 单选题Which line from the output of the show ip interface command indicates a layer 1 problem?（）A Serial0/1 is up, line protocol is downB Serial0/1 is down, line protocol is downC Serial0/1 is up, line protocol is upD Serial0/1 is administratively down, line protocol is down
查看答案
考题 单选题While logged into a router you manually shut down the serial 0 interface using the "shutdown" interface configuration command. You then issue the "show interface serial 0" command in exec mode. What could you expect the status of the serial 0 interface to be?（）A Serial 0 is up, line protocol is upB Serial 0 is up, line protocol is downC Serial 0 is down, line protocol is downD Serial 0 is down, line protocol is upE Serial 0 is administratively down, line protocol is downF Serial 0 is administratively down, line protocol is up
查看答案
考题 单选题如果链路的一端被管理DOWN，你将看到的另一端接口状态输出信息是（）A interface is down，line protocol is downB interface is down，line protocol is upC interface is up，line protocol is downD interface is up，line protocol is up
查看答案
考题 单选题Refer to the exhibit.What is the reason that the interface status is “administratively down,line protocol down”?（）A There is a mismatch in encapsulation typesB The wrong type of cable is connected to the interfaceC The interface has been configured with the shutdown commandD The interface is not receiving any keepalivesE The interface needs to be configured as a DTE deviceF There is no encapsulation type configured
查看答案
热门标签
最新试卷