思科认证 2021_06_08 每日一练
Both bridges are switches are being used throughout the Ezonexam LAN. Which of the following statements are true regarding bridges and switches in this network?
(Choose 3)
A. Switches are primarily software based while bridges are hardware based.
B. Switches usually have a higher number of ports than most bridges.
C. Bridges are frequently faster than switches.
D. Bridges define broadcast domains while switches define collision domains.
E. Both bridges and switches forward Layer 2 broadcasts.
F. Both bridges and switches make forwarding decisions based on Layer 2 addresses.
The 213.115.77.0 network was subnetted using a /28 subnet mask. How many usable subnets and host addresses per subnet were created as a result of this?
A. 2 networks with 62 hosts
B. 6 networks with 30 hosts
C. 16 networks and 16 hosts
D. 62 networks and 2 hosts
E. 14 networks and 14 hosts
F. None of the above
The IP network 210.106.14.0 is subnetted using a /24 mask. How many usable networks and host addresses can be obtained from this?
A.1 network with 254 hosts
B.4 networks with 128 hosts
C.2 networks with 24 hosts
D.6 networks with 64 hosts
E.8 networks with 36 hosts
Which of the following services use TCP? (Choose three)
A. DHCP
B. SMTP
C. SNMP
D. FTP
E. HTTP
F. TFTP
What must the Ezonexam network administrator do in order to successfully configure a VLAN trunk between two switches named VE1 and VE2? (Select two answer choices)
A. Set each end of the trunk line to IEEE 802.1Q encapsulation.
B. Set the same VTP management domain name on both switches.
C. Set all ports on the two switched as access ports.
D. Configure one of the two switches as a VTP server.
E. Connect the two switches using a rollover cable.
F. Use a router to forward VTP traffic between the VLANs.
When is a switched network that is running the Spanning Tree Protocol considered to be fully converged?
A.when all switches have the same BID as the root switch
B.when all switches have received the MAC address of each neighboring switch
C.when every enabled switch port has been assigned a unique identifier
D.when every operating switch port is in either the blocking or forwarding state
E.when all switches are in either client, server, or transparent mode