网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
Refer to the exhibit. What can be determined about the router from the console output?()
A.No configuration file was found in NVRAM.
B.No configuration file was found in flash.
C.No configuration file was found in the PCMCIA card.
D.Configuration file is normal and will load in 15 seconds.
参考答案
更多 “ Refer to the exhibit. What can be determined about the router from the console output?() A.No configuration file was found in NVRAM.B.No configuration file was found in flash.C.No configuration file was found in the PCMCIA card.D.Configuration file is normal and will load in 15 seconds. ” 相关考题
考题
Refer to the exhibit. This shows the NetFlow statistics for a router. You are analyzing the traffic pattern and you are interested in the percentage of packets between 32 and 64 bytes in size and the number of flows in progress. Which of these identifies both numbers correctly?（）A. 69.4%, 4061B. 24.9%, 980C. 69.4%, 35D. 6.94%, 980E. cannot be determined from this output
考题
The fol lowing line of output was extracted from the output of the show ip bgp command on Router R1. Which of the following can be determined from this output?（）Network Next Hop Metric LocPrf Weight Path* 130.1.1.0/28 1.1.1.1 0 1 2 3 4 iA. The route is learne d from an eBGP peerB. The route has no more than three ASNs in the AS_PatHC. The route is the best route for this prefixD. None of these facts can be positively determined by this output
考题
Refer to the exhibit. Based on this command output, what can we conclude about R3?()
A. R3 is an ABR.B. R3 is not connec ted to the backbone.C. R3 has four neighbors.D. R3 is the DR for area 2.
考题
Refer to the exhibit. You have completed an OSPF implementation, and you are verifying OSPF operation. You notice that router A and router B are stuck in the two - way state. From the show ip ospf interface command output, what is the cause of this issue?（）A. All OSPF implementations must have at le ast one interface in area 0.B. You are attempting to run in the broadcast mode over an NBMA interface.C. Both routers are configured to function as a BDR; therefore, there is no DR router.D. Someone has changed the OSPF router ID; therefore you must clear the OSPF process.E. The OSPF priority is set to 0 on both routers; therefore neither can become the DR.
考题
Refer to the parti al configurations in the exhibit. What address is utilized for DR and BDR identification on Router1?()
A. the serial 1/1 addressB. the serial 2/0 addressC. a randomly generated internal addressD. the configured router - id address
考题
Refer to the exhibit. Which statement is true about the router configuration that is shown ?Select the best response.()
A. Additional DHCP options will be imported from another DHCP server.B. The DHCP server pools need to be bound to an interface to operate.C. This configuration will provide IP configuration information to two different su bnets.D. Additional DCHP option information needs to be imported from another DHCP server.E. If the router hands out all the addresses in pool 1, then it will supply addresses from pool 2.
考题
Refer to the exhibit. What three statements are true about the IS － IS configuration?()
A.The router is in area 49.0001.0002B.The router acts as a Level 1 - 2 routerC.CLNS routing is enable d for the routerD.The router has a system ID of 0003.0004E.The interfaces have a functional IS - IS configurationF.The network service access point selector (NSEL) byte has a value of 0
考题
Refer to the exhibit. Which two conclusions can be drawn from the debug ip igmp output?()
A. The router sent an IGMP version 2 query out interface Ethernet1 at multicast address 224.0.0.1.B. Router RTA received an IGMP report version 1 from host 192.168.9.1.C. Reverse Path Forwarding (RPF) is ena bled for 192.168.9.4.D. Reverse Path Forwarding (RPF) is enabled for 224.0.1.40.E. The IP multicast groups are 224.0.0.1, 224.0.1.40, and 239.255.0.1.F. IP PIM RP mapping is static.
考题
Refer to the exhibit. By default, when RTB passes BGP advertisements from RTA about network 192.168.2.0 to RTC, what address will be listed as the next － hop address? ()
A. 10.1.1.2B. 192.168.1.49C. 10.1.1.1D. 192.168.1.50
考题
Above is the output from show ip bgp neighbors command. What is line 21 stating about the BGP connection?()
A. the number of consecutive TCP connections to the specified remote neig hborB. the number of total TCP connections that the router hasC. the number of times the router has established a TCP connectionD. the number of neighbors that the router has
考题
Refer to the exhibit. EIGRP is configured on all routers in the network. On a basis of the show ip eigrp topology output provided, what conclusion can be deri ved? ()
A.Router R1 is waiting for a reply from the neighbor 10.1.2.1 to the hello message sent out inquiring for a second successor to network 10.6.1.0/24B.Router R1 can send traffic destined for network 10.6.1.0/24 out of interface FastEthernet0/0C.Router R1 is waiting for a reply from the neighbor 10.1.2.1 to the hello message sent out before it declares the neighbor unreachableD.Router R1 is waiting for a reply from the neighbor 10.1.2.1 in response to the query sent out about network 10 .6.1.0/24
考题
Refer to the exhibit. When running OSPF, What would cause router A not to form an adjacency with router B?()
A.The loopback addresses are on different subnetsB.The value of the dead timers on the router are differentC.Route summarization is enabled on both routersD.The process indentifier on router A is different than the process identifier on router B
考题
Refer to the exhibit. A network technician is asked to design a small network with redundancy. The exhibit represents this design, with all hosts configured in the same VLAN. What conclusions can be made about this design?（）A.The design will function as intendedB.Spanning-tree will need to be used.C.The router will not accept the addressing scheme.D.The connection between switches should be a trunk.E.The router interfaces must be encapsulated with the 802.1Q protocol.
考题
Refer to the exhibit. For what two reasons has the router loaded its IOS image from the location that is shown? ()
A.Router1 has specific boot system command that instruct it to load IOS from TFTP server.B.Router1 is acting as a TFTP server for other routers.C.Router1 cannot locate a valid IOS image in flash memory.D.Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.E.Cisco routers will first attempt to load a image from TFTP for management purposes.
考题
Refer to the exhibit. What is the meaning of the output MTU 1500 bytes?()
A.Themaximumnumberofbytesthatcantraversethisinterfacepersecondis1500.B.Theminimumsegmentsizethatcantraversethisinterfaceis1500bytes.C.Theminimumpacketsizethatcantraversethisinterfaceis1500bytes.D.Themaximumpacketsizethatcantraversethisinterfaceis1500bytes.E.Themaximumframesizethatcantraversethisinterfaceis1500bytes.
考题
Refer to the exhibit. What does the (*) represent in the output?()
A.Packet is destined for a local interface to the router.B.Packet was translated, but no response was received from the distant device.C.Packet was not translated, because no additional ports are available.D.Packet was translated and fast switched to the destination.
考题
What can be determined from the line of show ip route output shown in the exhibit?（）A、The next routing update can be expected in 35 seconds.B、The IP address 10.10.10.6 is configured on S0/1.C、The IP address 10.10.10.8 is configured on S0/1.D、This route is using the default administrative distance.E、The 10.10.10.8 network is two hops away from this router.
考题
What is true about access control on bridged and routed VLAN traffic？ （）A、 Router ACLs can be applied to the input and output directions of a VLAN interface.B、 Bridged ACLs can be applied to the input and output directions of a VLAN interface.C、 Only router ACLs can be applied to a VLAN interface.D、 VLAN maps and router ACLs can be used in combination.E、 VLAN maps can be applied to a VLAN interface
考题
Refer to the exhibit. For what two reasons has the router loaded its IOS image from the location that is shown? （）A、Router1 has specific boot system command that instruct it to load IOS from TFTP server.B、Router1 is acting as a TFTP server for other routers.C、Router1 cannot locate a valid IOS image in flash memory.D、Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.E、Cisco routers will first attempt to load a image from TFTP for management purposes.
考题
What is true about access control on bridged and routed VLAN traffic？（）A、Router ACLs can be applied to the input and output directions of a VLAN interfaceB、Bridged ACLs can be applied to the input and output directions of a VLAN interfaceC、Only router ACLs can be applied to a VLAN interfaceD、VLAN maps and router ACLs can be used in combinationE、VLAN maps can be applied to a VLAN interfac
考题
单选题Refer to the exhibit. Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this RouterD?（）A
10.1.1.2B
10.154.154.1C
172.16.5.1D
192.168.5.3
考题
多选题What is true about access control on bridged and routed VLAN traffic？（）ARouter ACLs can be applied to the input and output directions of a VLAN interfaceBBridged ACLs can be applied to the input and output directions of a VLAN interfaceCOnly router ACLs can be applied to a VLAN interfaceDVLAN maps and router ACLs can be used in combinationEVLAN maps can be applied to a VLAN interfac
考题
单选题Refer to the exhibit. A network technician is asked to design a small network with redundancy. The exhibit represents this design, with all hosts configured in the same VLAN. What conclusions can be made about this design?（）A
The design will function as intendedB
Spanning-tree will need to be used.C
The router will not accept the addressing scheme.D
The connection between switches should be a trunk.E
The router interfaces must be encapsulated with the 802.1Q protocol.
考题
多选题What can be determined from the line of show ip route output shown in the exhibit?（）AThe next routing update can be expected in 35 seconds.BThe IP address 10.10.10.6 is configured on S0/1.CThe IP address 10.10.10.8 is configured on S0/1.DThis route is using the default administrative distance.EThe 10.10.10.8 network is two hops away from this router.
考题
单选题What can be determined about an injury from examining the condition of a victim’s pupils? （）A
The degree of pain being sufferedB
The degree of vision impairmentC
Whether or not the brain is functioning properlyD
Whether or not the victim's blood pressure is normal
考题
单选题The fol lowing line of output was extracted from the output of the show ip bgp command on Router R1. Which of the following can be determined from this output?（） Network Next Hop Metric LocPrf Weight Path * 130.1.1.0/28 1.1.1.1 0 1 2 3 4 iA
The route is learne d from an eBGP peerB
The route has no more than three ASNs in the AS_PatHC
The route is the best route for this prefixD
None of these facts can be positively determined by this output
考题
多选题What is true about access control on bridged and routed VLAN traffic？ （）ARouter ACLs can be applied to the input and output directions of a VLAN interface.BBridged ACLs can be applied to the input and output directions of a VLAN interface.COnly router ACLs can be applied to a VLAN interface.DVLAN maps and router ACLs can be used in combination.EVLAN maps can be applied to a VLAN interface
热门标签
最新试卷
