网友您好， 请在下方输入框内输入要搜索的题目：
题目内容
（请给出正确答案）
When designing the coverage area for high call capacity, what two actions should be done with data rates and channels?（）
- A、Avoid channels with high AP co-channel interference.
- B、Use channels with high AP co-channel interference to avoid channel roams.
- C、Set the 2.4-GHz data rate of 5.5 Mb/s to required.
- D、Use 5-GHz channels when possible.
- E、Use 2.4-GHz channels when possible.
参考答案
更多 “When designing the coverage area for high call capacity, what two actions should be done with data rates and channels?（）A、Avoid channels with high AP co-channel interference.B、Use channels with high AP co-channel interference to avoid channel roams.C、Set the 2.4-GHz data rate of 5.5 Mb/s to required.D、Use 5-GHz channels when possible.E、Use 2.4-GHz channels when possible.” 相关考题
考题
The approaching 4G mobile communication systems are projected to （ ） still remaining problems of 3G systems and to provide （ ） new services ,from high-quality voice to high-definition video to high data-rate wireless channels.[1分]A.solveB.solvingC.reduceD.increase
考题
In your database, the flash recovery area (FRA) is configured as the default for RMAN backups. You executed the following commands to configure the settings in RMAN:Which statement is true about the outcome?（）A. Only one channel is allocated and the backup is created in the flash recovery areaB. Only one channel is allocated and the backup is created in the destination specified for channelC. Two channels are allocated and backup sets are created in the destinations specified for channels 1 and 2D. Three channels are allocated and backup sets are created in the destinations specified for channels 1, 2, and FRA
考题
Examine the following set of RMAN commands:Which statement is true when the RMAN RUN block Is executed?()
A. The execution of the script fails because multiple channels cannot coexist.B. The script is executed and both the channels are used for the script execution.C. The new channel, CHI, is Ignored because a channel has been configured already.D. ration parameter DC1 is overridden because a new channel is allocated in RMAN RUN block.
考题
Click the Exhibit button. When designing a DWDM system with multiple amplified spans, a pre－amp is needed at Site B to (). (Choose three.)
A. offset the OADM loss at site bB. overcome the high multiplexer loss at site aC. amplify signal levels after the high loss through Fiber Span 1D. adjust add channels at site B to be at the same level as the passthrough channelsE. ensure that the per channel power is higher than the minimum needed for the post-amp at Site b
考题
What three in combination are factors that can cause four－wave mixing in fiber－optic cables? ()(Choose three.)
A. low optical powerB. high optical powerC. few optical channelsD. many optical channelsE. low chromatic dispersionF. high chromatic dispersionG. too much power differential in the optical channels
考题
What are two important considerations when using 2－ or 4－channel 15216 OADMs?() (Choose two.)
A. All Add channels require uniform power levels.B. The flexibility of wavelengths per OADM is limited.C. It is easier to balance Pass-Through and Add channels.D. There is lower pass-through loss using multi-channel OADMs.E. You can extract a single channel without dropping other channels.
考题
The ONS 15216 is a 32－channel system. The ONS 15216 OADMs are capable of adding and dropping one, two, or four channels. How are the OADMs provisioned to add and drop specific channels?()
A. The ONS 15216 OADM can be provisioned to add/drop one, two, or four channels via Cisco Transport Manager (CTM).B. The ONS 15216 OADM consists only of a four-channel module, and the number of ports utilized determines whether it is a one, two, or four channel OADM.C. Three separate OADM modules are available for one, two, and four channels. The wavelengths to be dropped and added are programmable via Cisco Transport Manager (CTM).D. The ONS 15216 OADM consists only of a single-channel module. Two-channel and four-channel support is available by stacking the single-channel module.E. The ONS 15216 OADM is available in one, two, four channels. There are 32 single-channel OADM modules, 16 two-channel OADM modules, and 8 four-channel OADM modules.
考题
What is the inegge mainly expressed in the story?A.we should learn to he generousB.It is honorable to help those in need.C.People in high postans are not like what we expectD.We should avoid judging people by their appearances.
考题
What is the message mainly expressed in the story?A. We should learn to be generous.B. It is honorable to help those in need.C. People in high positions are not like what we expect.D. We should avoid judging people by their appearances.
考题
What three in combination are factors that can cause four-wave mixing in fiber-optic cables？（）A、 low optical poweB、 high optical powerC、 few optical channelsD、 many optical channelsE、 low chromatic dispersionF、 high chromatic dispersionG、 too much power differential in the optical channels
考题
What is the use of NPV in Cisco Unified Computing Systems？ （） A、 Compatibility with third-party Fibre Channel switchesB、 Faster throughputC、 Reduce domain IDs in a Fibre Channel environmentD、 Support for increased number of VSANsE、 Support for SAN port channels
考题
To avoid shock ,you should reduce speed by（）（低速）control.A、low speedB、high speedC、inchingD、slow speed
考题
A design requires 100 access points with high channel bandwidth and disabled lower data rates.How are the data rates set on the Cisco WLC and Cisco WCS？（）A、per SSIDB、per access pointC、globallyD、per WLAN and radio
考题
What are two important considerations when using 2- or 4-channel 15216 OADMs?（） (Choose two.)A、All "Add" channels require uniform power levels.B、The flexibility of wavelengths per OADM is limited.C、It is easier to balance "Pass-Through" and "Add" channels.D、There is lower pass-through loss using multi-channel OADMs.E、You can extract a single channel without dropping other channels.
考题
What are two important considerations when using 2- or 4-channel 15216 OADMs？（）A、 All "Add" channels require uniform power levels.B、 The flexibility of wavelengths per OADM is limited.C、 It is easier to balance "Pass-Through" and "Add" channels.D、 There is lower pass-through loss using multi-channel OADMs.E、 You can extract a single channel without dropping other channels.
考题
What three in combination are factors that can cause four-wave mixing in fiber-optic cables? （）(Choose three.)A、low optical powerB、high optical powerC、few optical channelsD、many optical channelsE、low chromatic dispersionF、high chromatic dispersionG、too much power differential in the optical channels
考题
What two benefits result from Cisco WLC configuration of DCA for 5-GHz VoWLAN deployments?（）A、Avoid channels with microwave oven noise.B、Manually remove channels not supported by the VoWLAN clients.C、Avoid 802.11n 40-MHz wide channels.D、Automatically avoid nearby radar.
考题
Which three call information items does AirMagnet VoFi Analyzer provide? （）A、the codec used by the calling phoneB、approximate length of the call in minutesC、MOS values throughout the duration of the callD、802.11e access category overrunsE、co-channel interference percentage during the call
考题
Which type of interference is produced by other transmitters on the same frequency? （）A、Double interferenceB、Co-channel interferenceC、Adjacent channel interferenceD、Reflected interferenceE、Timing interference
考题
What type of interference is produced by other transmitters on the same frequency? （）A、Double interferenceB、Co-channel interferenceC、Adjacent channel interferenceD、Reflected interferenceE、Timing interference
考题
Which statement about SAN port channels configured on Cisco Nexus 5000 Series Switches is true？（） A、 A single SAN port channel can have both Fibre Channel and virtual Fibre Channel interfaces. B、 SAN port channels can include up to 16 interfaces.C、 SAN port channels distribute traffic across all links in the port channel when source ID and destination ID load balancing are used.D、 The links in SAN port channels can be connected to different sets of switches.E、 The On mode of operation means ports only operate as part of a SAN port channel or remain inactive.
考题
单选题When a crankshaft （） outside the engine, it should be carefully supported in a manner which will avoid imposing high bending moments on it.A
has to be handledB
may be handledC
has being handledD
will be handling
考题
多选题What is the use of NPV in Cisco Unified Computing Systems？ （）ACompatibility with third-party Fibre Channel switchesBFaster throughputCReduce domain IDs in a Fibre Channel environmentDSupport for increased number of VSANsESupport for SAN port channels
考题
多选题When designing the coverage area for high call capacity, what two actions should be done with data rates and channels?（）AAvoid channels with high AP co-channel interference.BUse channels with high AP co-channel interference to avoid channel roams.CSet the 2.4-GHz data rate of 5.5 Mb/s to required.DUse 5-GHz channels when possible.EUse 2.4-GHz channels when possible.
考题
多选题What two benefits result from Cisco WLC configuration of DCA for 5-GHz VoWLAN deployments?（）AAvoid channels with microwave oven noise.BManually remove channels not supported by the VoWLAN clients.CAvoid 802.11n 40-MHz wide channels.DAutomatically avoid nearby radar.
考题
单选题When a crankshaft has to be handled outside the engine, it should be carefully supported in a manner which will avoid （） high bending moments on it.A
compressingB
interposingC
imposingD
pounding
考题
单选题Which statement about SAN port channels configured on Cisco Nexus 5000 Series Switches is true？（）A
A single SAN port channel can have both Fibre Channel and virtual Fibre Channel interfaces. B
SAN port channels can include up to 16 interfaces.C
SAN port channels distribute traffic across all links in the port channel when source ID and destination ID load balancing are used.D
The links in SAN port channels can be connected to different sets of switches.E
The On mode of operation means ports only operate as part of a SAN port channel or remain inactive.
热门标签
最新试卷
