HP HP0-236 认证考试试题

1.Click the Task button.

Configuration changes in a fabric result in more or less temporary performance reduction. Arrange the events in the correct sequence, from lowest to highest performance impact, by dragging and dropping the boxes.

 

Click the Exhibit button for instructions on completing Drag and Drop items.

Drag and drop question. Drag the items to the proper locations.

2.What must you use to establish a communication link between two existing fabrics with different PID bit settings?

 

A: a router

B: a bridge

C: virtual SANs

D: tunneling

 

3.Which zoning method is supported in a fabric with a mix of B-series and C-series switches?

 

A: domain/port zoning on B-series switches

B: node WWN zoning on B-series switches

C: port WWN zoning on C-series switches

D: node WWN zones on C-series switches

 

4.What does the HP SAN Security Services Product provide?

 

A: security services which include the implementation of third party security products

B: security services which include security review, planning and ongoing audit

C: fiber optic components which do not emit electromagnetic radiation

D: product specific installation and maintenance, but no security audit

 

5.What is a design recommendation for selecting switches to build a SAN?

 

A: For configuration flexibility, use switches from different vendors.

B: Any mix of B-series, M-series and C-series switches is supported.

C: Use switches from a single vendor.

D: You can reduce cost by using switches from different vendors.

 

6.You are logged into a B-series switch and the following message displays:

 

WARNING ZONE-ZONEGROUPADDFAIL, 3, WARNING - port 7 Out of CAM entries

WARNING ZONE-SOFTZONING, 3, WARNING - port 7: zoning enforcement changed to SOFT

 

Why?

 

A: The GBIC (gigabit interface converter) on port 7 is defective.

B: The device connected to port 7 was replaced.

C: The limit of 64 unique SID entries per quad is exceeded.

D: The switch lost the zoning information for port 7.

 

7.Which factor can reduce the performance between devices in a Fibre Channel SAN?

 

A: hop count

B: switch latency

C: inter-switch link latency

D: inter-switch link congestion

 

8.What allows you to check if the configuration of a new switch is compatible with an existing fabric configuration in a B-series fabric?

 

A: Network View

B: Fabric Manager

C: High Availabiity Fabric Manager

D: OpenView SAN Manager

 

9.When do you use Storage Allocater for storage provisioning and access control?

 

A: when enhanced security features must be set up to protect sensitive data

B: when the storage device is unable to do the Selective Storage Presentation

C: when quotas are required for users of shared storage devices

D: when multiple hosts with the same operating system share storage devices

 

10.What is the meaning of NEAR-ONLINE storage?

 

A: tape media in a library

B: disk drives for data with low access frequency

C: Network Attached Storage devices

D: drives in standby mode