HP HP0-242 认证考题

1.Adaptive Tape Speed _____.

A: slows down transmission speed if the tape drive cannot handle the load

B: enables the tape drive to adjust its performance to the incoming data rate

C: decompresses incoming data to provide enough performance to keep the drive streaming

D: automatically adjusts the compression ratio to the data type

 

2.Which LED indicates a power fault of the y-axis motor?

 

A: LED 1 on the upper actuator driver board (AD0)

B: LED 2 on the lower actuator driver board (AD1)

C: LED 1 on the lower actuator driver board (AD1)

D: LED 2 on the upper actuator driver board (AD0)

 

3.Which connection type has the highest priority when connecting to a Network Storage Router (NSR) through the Interface Manager card?

 

A: Command View ESL

B: Telnet

C: FTP

D: Serial

 

4.Which command on the front panel resets the statistical counters of the library?

 

A: CALIBRATE ALL CONFIGURATION from the operator menu.

B: CALIBRATE ALL STATISTICS from the operator menu.

C: INITIALIZE NONVOLATILE MEMORY STATISTICS from the service menu.

D: INITIALIZE NONVOLATILE MEMORY CONFIGURATION from the service menu.

 

5.Click the Exhibit button.

 

Which library and tape drive firmware must be used for an ESL9322 with Ultrium 460 tape drives and Data Protector?

A: Robot firmware 3.48, tape drive firmware F3CW

B: Robot firmware 3.40, tape drive firmware F3CW

C: Robot firmware 3.40, tape drive firmware F43W

D: Robot firmware 3.48, tape drive firmware F43W

 

6.An ESL9000 library is connected to a Network Storage Router NSR E1200 connected to a Fibre Channel hub. Which NSR E1200 Fibre Channel port parameters can prevent a host with a 1 Gb connection to the same Fibre Channel hub from accessing the ESL9000? Select TWO.

 

A:Port Mode = N-Port

B:Use Hard AL_PA = disabled

C:Performance Mode = 2 Gb

D:WW Node Name High = 100000E0

E:WW Node Name Low = 0201FF96

 

7.From which Operator Control Panel screen can you configure library options?

 

A: License

B: Tapes

C: Services

D: Operator

 

8.On the Overview screen of the Operator Control Panel, which information on the drive status is NOT provided?

 

A: cartridge is loaded or unloaded

B: loaded cartridge is write-enabled or write-protected

C: drive error code

D: compression is enabled or disabled

 

9.What is the purpose of the Command View ESL?  Select TWO.

 

A:Storage Management Appliance integration

B:remote server firmware update

C:license key summary

D:remote library power cycle

E:device monitoring

 

10.The host is connected to which SCSI port of an ESL9595?

 

A: H

B: M

C: Q

D: R