HP HP0-238 认证考试试题

1.Click the Task button.

Identify the MSA1000 Redundancy Active indicator by clicking the number that specifies its location.

Hotspot question. Click on the correct location or locations in the exhibit.

2.This item is a Drag and Drop response item.  Click the Exhibit button for instructions on completing Drag and Drop items.

 

Click the Task button.

 

You are adding an additional split bus M4354 storage enclosure to an MSA1000. Match the SCSI busses to the enclosure by dragging and dropping the boxes.

Drag and drop question. Drag the items to the proper locations.

3.Click the Exhibit button.

 

Which LED on the MSA1000 controller indicates a failure on a configured hard disk?

A: LED 9

B: LED 15

C: LED 16

D: LED 17

 

4.A Wide Ultra 3 SCSI bus has 16 possible SCSI IDs and a bandwidth of up to ______.

 

A: 20 MB/s with an SE or LVD interface

B: 40 MB/s with an SE or HVD interface

C: 80 MB/s with an SE or LVD interface

D: 160 MB/s with an LVD interface

 

5.An MSA1000 controller fails before cached data is written to the disks. What happens to the data?

 

A: The data will be lost.

B: After the failed controller has been replaced, the data must be flushed manually.

C: After the failed controller has been replaced, the data is flushed automatically.

D: The data remains intact due to the battery backed cache.

 

6.RAID Level 0 ____.  Select TWO.

 

A:usually has the highest cost per GB of usable space because it duplicates the data

B:usually has the lowest cost per GB of usable space

C:is used primarily in environments requiring fault tolerance and best performance

D:has moderate costs per GB because it uses only one disk for parity per array

E:does not provide fault tolerance

 

7.The customer has a single controller MSA1000 configuration. What is the recommended action to replace the failed controller?

 

A: Power down the MSA1000. Remove the failed controller and install the old cache module in the replacement controller.

B: Push the right arrow push button on the front panel to clear the cache of the controller and replace the failed controller.

C: Replace the failed controller online, with a new cache installed.

D: Push the left arrow push button on the front panel to clear the cache of the controller and replace the failed controller.

 

8.You handled an error which was indicated by a message on the MSA1000 text display window. How do you delete the message?

 

A: You cannot delete the message.

B: Press the left and right push buttons at the same time.

C: Issue the DEL MSG command to delete the currently displayed message.

D: Issue the DEL MSG command to clear the complete message buffer.

 

9.Which command must be issued before performing a firmware update to the MSA1000 Fabric Switch 2/8 throuch the CLI?

 

A: switchstop

B: stop switch

C: disable switch

D: switchdisable

 

10.You are assigning DISK109 as a spare drive to array B containing logical drives 2 and 3. What is the correct CLI (command line interface) command?

 

A: ADD SPARE UNIT=2  DISK109

B: ADD SPARE ARRAY B DISK109

C: SET SPARE ARRAY B DISK109

D: SET SPARE  UNIT 3 DISK109