HP HP0-794 认证题库

1.Which SQL Server clustering requirement changed between SQL 7.0 and SQL 2000?

 

A: Only licenses for the first node in the cluster were required for SQL 7.0; all nodes must have licenses for SQL 2000.

B: Multiple virtual SQL servers could not run on the same set of disks for SQL 7.0, but can run on the same set of disks for SQL 2000.

C: Binaries are on the shared disk for SQL 7.0, but on the local disk for SQL 2000.

D: Microsoft Transaction Server and Microsoft Queue Manager are no longer included as components of SQL 2000.

 

2.What is a SQL Server pre-installation requirement?

 

A: The group must initially contain at least two disk resources.

B: The group requires a shared IP address.

C: Microsoft Distributed Transaction Coordinator must be configured for the cluster.

D: The SQL Server Agent must be installed.

 

3.What is one of the functions of the cluster node command?

 

A: Rename a cluster node.

B: Check the status of node resources.

C: Pause a cluster node.

D: Power down a cluster node.

 

4.Which HP utility should be used to update the Smart Array controller or MSA 1000 storage system firmware in a cluster system?

 

A: ProLiant Support Paq

B: Options ROMPaq

C: System Configuration Utility

D: Array Configuration Utility

 

5.What are ways that HP ProLiant clusters ensure reliability and investment protection of new and existing clusters? Select TWO.

 

A:certified servers

B:cluster application white papers

C:cost-effective migration paths across all cluster configurations

D:cluster migration kits for automating cluster migrations

E:customized versions of operating systems for cluster integration and migrations

 

6.Which utility should you use to verify that all disk resources are visible to the server and that all of the drive letters match exactly those assigned on the other cluster node?

 

A: Microsoft Cluster Administrator

B: Intelligent Cluster Administrator

C: Microsoft Disk Management

D: HP Cluster Verification Utility

 

7.You changed the cluster IP address and subnet mask for your internal cluster communication network. This created a new cluster network on the cluster. How do you change the properties of the network connection to restore the original setting for network use?

 

A: With both nodes powered on, open My Network Places on the first node and return the settings for the new cluster network connection to the original setting for the New Cluster Network; then perform the same procedure on the second node.

B: With the second node powered off, open My Network Places and return the settings for the new cluster network connection to the original setting for the New Cluster Network; then power off the first node, power on the second, and perform the same procedure on the second node.

C: With both nodes powered on, open Microsoft Cluster Administrator and return the settings for the new cluster network connection to the original setting for the New Cluster Network.

D: With the second node powered off, open Microsoft Cluster Administrator and return the settings for the new cluster network connection to the original setting for the New Cluster Network; then power off the first node, power on the second, and perform the same procedure on the second node.

 

8.When creating a clustered volume mount point on a cluster node, which requirement must be met? The partition to be mounted must be ______.

 

A: created on the Quorum disk

B: mounted to a shared disk in a different group

C: created on a non-clustered disk

D: formatted using NTFS

 

9.Which clustering technology builds middle-tier clusters to load balance COM+ components?

 

A: Network Load Balancing (NLB)

B: Component Load Balancing (CLB)

C: Cluster service

D: N-tier balancing

 

10.Which version of Microsoft Windows Server 2003 supports systems using up to 32-way symmetric multiprocessing?

 

A: Advanced Edition

B: Datacenter Edition

C: Enterprise Edition

D: Professional Edition

E: Standard Edition