HP HP0-790 认证题库

1.Click the Task button. Arrange the steps to associate an IP address with an existing VLAN on a ProCurve Routing Switch 9300m.

Drag and drop question. Drag the items to the proper locations.

2.Click the Task button. Arrange the steps necessary to enable RIP on the ProCurve Switch 5300xl.

Drag and drop question. Drag the items to the proper locations.

3.A network design calls for two ProCurve 9300m routing switches to provide VRRP services to four VLANs. No other routers will participate in these VRIDs. How can the designer enable load sharing between the routers?

A: Configure both routers with the same VRRP priority value.

B: Configure each router to be Master for two VRIDs.

C: Configure all links between the routers to carry all VLANs.

D: Configure all VLANs for redundant links to both routers.

 

4.Which type of interface is associated with a routing switch but not with a traditional router?

 

A: physical

B: redundant

C: virtual

D: loopback

 

5.An administrator enters enable super-user-password password at the CLI of a ProCurve Routing Switch 9300m. How does this command affect the privileges available in the User EXEC access level?

 

A: User EXEC privileges are greatly reduced.

B: User EXEC privileges are not affected by this command.

C: User EXEC privileges are identical to Privileged EXEC privileges.

D: User EXEC privileges are eliminated until the administrator configures a read-only user.

 

6.All interfaces of a ProCurve Switch 5300xl are members of OSPF area 5. What does this indicate?

 

A: Area 5 is a transit area.

B: Area 5 is a not so stubby area (NSSA).

C: The 5300xl is an internal router.

D: The 5300xl cannot be elected Designated Router.

 

7.You must install a new ProCurve Routing Switch 9300m at a customer site that uses VRRPE. The new 9300m will share a VRID with another 9300m. Which configuration parameter determines which router becomes Master of the VRID?

 

A: MAC address

B: root priority

C: IP address

D: backup priority

 

8.On the ProCurve Routing Switch 9300m, what is a difference between hardware-based ACLs and flow-based ACLs?

 

A: Hardware-based ACLs must be extended ACLs. Flow-based ACLs can be extended or standard.

B: Hardware-based ACLs use the route table in the management module to perform lookups. Flow-based ACLs use the interface module's session table.

C: Packets subject to flow-based ACLs are compared with session table entries. Packets subject to hardware-based ACLs are compared with CAM entries.

D: The application of hardware-based ACLs results in static CAM entries. CAM entries for flow-based ACLs are created as needed and aged out when not needed.

 

9.What is a valid application for ACLs on the ProCurve Routing Switch 9300m?

 

A: balancing traffic across redundant links

B: defining address pools to be used in NAT

C: summarizing routes learned through OSPF

D: choosing between equal-cost paths in the IP route table

 

10.On the ProCurve Routing Switch 9300m, which step is necessary to enable the logging of system events related to ACL matching?

 

A: Enable ACL logging in the global configuration context.

B: Enable ACL logging in the configuration context for a named ACL.

C: Use the log parameter in the statement that creates an ACL entry.

D: Use the log parameter in the statement that binds an ACL to an interface.